Brother Server Version 0 ENG 사용자 설명서
30
Configuring your machine for a wireless network (For HL-5470DW(T) and HL-6180DW(T))
3
a
Press a or b to choose Network. Press OK.
b
Press a or b to choose WLAN. Press OK.
c
Press a or b to choose WPS w/PIN Code. Press OK.
d
When WLAN Enable? is displayed, press a to accept.
This will start the wireless setup wizard.
To cancel, press Cancel.
This will start the wireless setup wizard.
To cancel, press Cancel.
e
The LCD will show an 8 digit PIN and the machine starts searching for a WLAN access point/router.
f
Using a computer that is on the network, type “http://access point’s IP address/” into your browser.
(Where “access point’s IP address” is the IP address of the device that is used as the Registrar
(Where “access point’s IP address” is the IP address of the device that is used as the Registrar
) Go to
the WPS setting page and input the PIN which the LCD shows in step e to the Registrar and follow the
on-screen instructions.
on-screen instructions.
1
The Registrar is normally the WLAN access point/router.
Note
The setting page is different, depending on the brand of WLAN access point/router. See the instruction
supplied with your WLAN access point/router.
supplied with your WLAN access point/router.
Windows Vista
®
/Windows
®
7
3
If you are using your computer as a Registrar, follow these steps:
Note
• To use a Windows Vista
®
or Windows
®
7 computer as a Registrar, you need to register it to your network
in advance. See the instruction supplied with your WLAN access point/router.
• If you use Windows
®
7 as a Registrar, you can install the printer driver after the wireless configuration by
following the on-screen instructions. If you want to install the full driver and software package, follow the
steps uu Quick Setup Guide for installation.
steps uu Quick Setup Guide for installation.