Brocade Communications Systems 53-1001763-02 사용자 설명서

Frame Redirection

4

FIGURE 12

Single Host and Target

 demonstrates the flow of frame redirection traffic. A frame starts at the host with a 

destination to the target. The port where the appliance is attached to the host switch acts as the 
virtual initiator and the port where the appliance is attached to the target switch is the virtual 
target. 

Creating a frame redirect zone

The first time this command is run the following zone objects are created by default:

•

The base zone object, "red_______base".

•

The RD zone configuration, "r_e_d_i_r_c__fg".

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the zone 

–-

rdcreate command.

3. Enter the cfgSave command to save the frame redirect zones to the defined configuration.

Example  of creating a frame redirect zone.

The following example creates an RD Zone, given a host (10:10:10:10:10:10:10:10), target 
(20:20:20:20:20:20:20:20), VI (30:30:30:30:30:30:30:30), and VT (40:40:40:40:40:40:40:40):

switch:admin>zone --rdcreate 10:10:10:10:10:10:10:10 20:20:20:20:20:20:20:20 \
30:30:30:30:30:30:30:30 40:40:40:40:40:40:40:40 restartable noFCR

Deleting a frame redirect zone

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the zone 

--

rdDelete command to remove the base RD zone, "red_______base". 

When the base zone is removed, the RD zone configuration "r_e_d_i_r_c__fg” is removed as 
well.

3. Enter the zone 

cfgSave command to save changes to the defined configuration.

Example  of deleting a frame redirect zone.

switch:admin> zone --rddelete \ 
red_0917_10_10_10_10_10_10_10_10_20_20_20_20_20_20_20_20 

Viewing redirect zones

1. Connect to the switch and log in using an account assigned to the admin role.

2. Enter the cfgShow command.