Brocade Communications Systems 53-1001763-02 사용자 설명서

Fabric configurations for interconnectivity

A

Configuring LSAN zones in the M-EOS fabric

To ensure connectivity with devices in the Fabric OS fabric, you must set up LSAN zones in each 
edge fabric.

An LSAN is defined by a zone in an edge fabric. When zoning an LSAN containing multiple fabrics 
with switches that are not running Fabric OS, you must use port WWN. Because port IDs are not 
necessarily unique across fabrics, you cannot use the domain,port method of identification.

If the LSAN is configured and the proxy devices are created, the proxy device will show in the name 
server of the edge fabric and the xlate domain will show in the fabric of the edge fabric. 

For more details about LSAN zoning, see 

The FC router can support up to 2048 zones when connected to an M-EOS v9.6 switch.

NOTE
For detailed instructions for the steps in the following procedure, refer to the Zoning User Manual. 

 web site under the Data 

Center Best Practices-Resource Center section and follow the instructions to access the 
documentation.

1. Log in to DCFM.

2. Create a new LSAN zone, as described in the Zoning User Manual. The name of the zone must 

use the LSAN_xxxx naming schema.

3. Add devices that are connected to the Fabric OS fabric. Use the device WWN when adding 

devices.

4. Add the newly created zone to the currently active zone set. 

5. Activate the updated zone set.

Correcting errors if LSAN devices appear in only one of the fabrics

If the LSAN devices appear in only one of the fabrics in a multiple-fabric SAN, use the following 
procedure to correct the problem.

1. Log in to each fabric and verify that all of the devices are physically logged in.

2. Verify that the devices are properly configured in the LSAN zone in both edge fabrics.

3. Enter the fabricShow command on the Fabric OS fabric.

4. Use M-EOS DCFM to verify the M-EOS fabric, including the front and translation domains.

5. Move back to the FC router and issue the fcrProxyDevShow command on to verify that the 

devices are configured and exported.

switch:admin> fcrproxydevshow
  Proxy           WWN             Proxy      Device   Physical    State
 Created                           PID       Exists     PID
in Fabric                                   in Fabric
----------------------------------------------------------------------------
    10   20:00:00:01:73:00:59:dd  05f001       12      610902   Imported
    10   21:00:00:e0:8b:04:80:76  02f002       11      340713   Imported
    10   50:06:01:68:40:04:d3:95  02f001       11      660713   Imported
    11   10:00:00:00:c9:2d:3d:5c  020001       10      011500   Imported