Alpine CDA-105RI 사용자 설명서
39
-EN
Installation
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Removal
1. Remove the detachable front panel.
2. Use a small screwdriver (or similar tool) to push the
locking pins to the “up” position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
3. Pull the unit out, keeping it unlocked as you do so.
Caution
When you install this unit in your car, do not remove the
detachable front panel.
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
might press too hard and warp the metal plate that holds it in
place.
1
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
Remove the mounting sleeve from the main unit (see
“Removal” on page 39). Slide the mounting sleeve
into the dashboard and fix it with the metal shackles.
“Removal” on page 39). Slide the mounting sleeve
into the dashboard and fix it with the metal shackles.
Detachable
Front Panel
Front Panel
Less than 35°
Bracket
Rubber Cap
(Included)
(Included)
Hex Bolt
(Included)
(Included)
This unit
Dashboard
Mounting Sleeve
(Included)
(Included)
Pressure Plates*
2
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the CDA-105Ri and put
the Rubber Cap on the hex bolt. If your vehicle does
not have the Mounting Support, reinforce the head
unit with the metal mounting strap (not supplied).
Connect all other leads of the CDA-105Ri according
to details described in the CONNECTIONS section.
hex bolt onto the rear panel of the CDA-105Ri and put
the Rubber Cap on the hex bolt. If your vehicle does
not have the Mounting Support, reinforce the head
unit with the metal mounting strap (not supplied).
Connect all other leads of the CDA-105Ri according
to details described in the CONNECTIONS section.
• For the screw *, provide a proper screw to the chassis installing
location.
3
Slide the CDA-105Ri into the dashboard. When the
unit is in place, make sure the locking pins are fully
seated in the down position. This can be done by
pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install
the detachable front panel.
unit is in place, make sure the locking pins are fully
seated in the down position. This can be done by
pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install
the detachable front panel.
∗
Metal Mounting Strap
Screw
Bolt Stud
This unit
Hex Nut (M5)
Lock Pin