Toshiba Strata CIX 개발자 가이드

The Destination System Number is the telephone number the remote node uses as 
identification. The format (including # signs): 1#area code#telephone number#. 
Example1#714#5551212#

10.In the Destination Dial Number field, type the telephone number including the area code and 

any special digits (e.g., 9) for dialing out. Example: 917145833777

11. (For AMIS Proxy User Agent only) In the Destination Mailbox field, accept the default or type 

in a different User Agent. Default is User Agent 998.

12. In the Notification Port Group field, accept the default or type in a different port group. Default 

is Q1.

See 

 for instructions on creating Notification Port 

Groups.

13. Using the spin button, set the Notify After(min), Continue Every(min) and Notify Max Time 

fields.

14. Click Submit. The data is saved.

15. Repeat 

 above for any other agents you created.

 

One method of testing AMIS involves using the AMIS Loopback User Agent (default 989). Once 
enabled using the sys_amis_ltm parameter, this User Agent can be used by other AMIS nodes for 
testing the network. Voice mail sends any AMIS message to this User Agent back to the sender, 
assuming the sending system is accessible from the voice mail system.

A line monitor can be used to analyze AMIS transmissions. However, to validate AMIS completely, 
an in-depth knowledge of AMIS Analog Protocol is required.

AMIS messages can only be sent from mailboxes.

AMIS networking operation consists of the following steps:

1. The user logs into his/her mailbox.

2. From the Main Menu, the user presses 

2

 for the Send Messages menu.

3. The user specifies the destination address as one of the following:

node + mailbox number – if the address is a unique combination of the Gateway mailbox 
and destination mailbox.

node + 

*

 + mailbox number – if the address is not a unique combination of the Gateway 

mailbox and destination mailbox.

Proxy User Agent number – if addressing the message to a Proxy User Agent.

where:

NODE = up to eight digits

remote address = up to 16 digits

4. The user records the message and presses 

#

 to stop recording.

5. The user presses 

#

 again to send the message to the specified node.