High End Systems Technobeam 사용자 설명서

Technobeam

®

 User Manual

6-19

You might need to realign the laser periodically in order to maintain its 
optimal position—no more than 2” (5 cm) directly above the center 
point of the light beam.  If you align the laser in this way, the path of 
the laser is parallel to the path of the light and will stay 2” (5 cm) above 
the center point of the beam at any throw distance or mirror position.

You align the laser using the three mounting/alignment screws shown 
in Figure 6-27 on page 6-25.

However, the decision of whether or not to align the laser is entirely up 
to you.  If the laser strays from its optimal position, but it gives you 
enough accuracy for your needs, you do not have to align it.

Figure 6-23 shows the ideal position of the laser from the center of a 
perfectly round light beam:

In addition to observing all of the cautions in the section titled 
“Precautions” on page 6-2, you must observe the following cautions 
whenever using or servicing the Laser Aiming Device (LAD):

1.

CAUTION:  Use of controls or adjustments or performance of 
procedures other than those specified herein may result in hazardous 
radiation exposure.

2.

Using the Laser Aiming Device with any fixture other than Technobeam 
may result in damage to both the laser and the fixture as well as 
exposure to laser radiation.

3.

Precautions should be taken to ensure that the laser beam is not 
unintentionally directed at mirror-like (specular) surfaces (most 
importantly, at flat mirror-like surfaces).

TM

Ideal laser spot

2" (5 cm) max