Perle Systems Iolan Sds4 Hl Device Server 4030370 사용자 설명서
Setting Jumpers 412
Introduction
5.
Close the IOLAN case by replacing the case lid and the two screws. You can now power it on
with the new settings.
with the new settings.
4-Port Desktop IOLAN
To change the settings, do the following:
1.
Unplug the IOLAN from the electrical outlet and disconnect everything from the box.
2.
Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the
case. You should see the following:
case. You should see the following:
3.
The following table describes how to jumper the pins for line termination, fixed 5V output, and
for output equal to the external adapter input:
for output equal to the external adapter input:
4.
Close the IOLAN case by replacing the case lid and the two screws. You can now power it on
with the new settings.
with the new settings.
Note:
Serial power in is not supported in the SDS2 PoE model.
Port #
Line Termination
5V Output
Input Volt Output
1
Jumper J7 for Full
Duplex
Jumper J8 for Half
Duplex
Jumper J8 for Half
Duplex Rx/Tx
J4, jumper pins 1 & 2
J4, jumper pins 2 &
3
3
2
Jumper J9 for Full
Duplex Rx
Jumper J11 for Half
Duplex Rx
Jumper J11 for Half
Duplex Rx/Tx
J5, jumper pins 1 & 2
J5, jumper pins 2 &
3
3
3
Jumper J22 for Full
Duplex Rx
Jumper J24 for Half
Duplex Rx
Jumper J24 for Half
Duplex Rx/Tx
J10, jumper pins 1 & 2 J10, jumper pins 2
& 3
4
Jumper J23 for Full
Duplex Rx
Jumper J25 for Half
Duplex Rx/Tx
Duplex Rx
Jumper J25 for Half
Duplex Rx/Tx
J6, jumper pins 1 & 2
J6, jumper pins 2 &
3
3
2
Power
DIP
Switch
Reset
RJ45
J1
1
J9
J7
J2
4
1
3
4
J8
J4
J5
J2
2
J1
0
J2
5
J2
J2
3
J6
Screw
Screw
The pin with the
square represents
Pin 1 --->
square represents
Pin 1 --->