Nu Technology NuIPC cPCI-6760DK/P5 사용자 설명서

Getting Started 

•

 33 

• 

Mount the DB-6760CF on the cPCI-6760DK/P5’s IDE connector (CN2).  

Please be aware that pin 1 on the DB-6760CF should be aligned with 
pin 1 of CN2 on the cPCI-6760DK/P5.   

• 

Fix the DB-6760CF & cPCI-6760DK/P5 by screwing three hexagonal 

pillars between them.  Leave the hole in front of the CF socket 
unscrewed.  

• 

Set the CF card as master or slave upon application requirements. 

• 

Insert a CF card into its socket, and then check to see if the CF card is 

probably seated 

• 

Mount the third screw on the upper side of the CF card to prevent the CF 

card from coming loose during heavy vibration. 

Note:   The CF card on the  CPU  board utilize the Secondary EIDE 

interface (IDE2), which is also wired to  the  CompactPCI 
connector J5. Users need to pay attention to the master/slave 
setting to avoid conflicts between devices.  The default jumper 
setting on the DB-6760CF is set to master.   

• 

Remove the upper screw, which prevents the CF card from coming 

loose 

• 

Remove the CF card by pushing the ejector level 

• 

Remove all screws & hexagonal pillars on the DB-6760CF 

• 

Remove the DB-6760CF carefully from the 44-pin IDE connector (CN2) 

of the cPCI-6760DK/P5