Dacor RNO127C208V 설치 설명서

다운로드
페이지 36
6
Installation Specifications
Installation Planning
 WARNING
Observe all governing codes and ordinances during plan-
ning and installation. Contact your local building depart-
ment for further information.
 IMPORTANT
•  Locate the junction box so that the oven may be easily 
disconnected in the event that it needs to be removed 
from the wall completely for service.
•  If the oven is not installed level it may deliver poor or 
inconsistent baking results.
•  Carefully check the location where the oven is to be 
installed. The oven should be placed for convenient 
access. Make certain that electrical power, meeting the 
specifications on page 4, can be provided in the 
selected location.
•  Dacor recommends installing the junction box in the 
one of the locations shown on the facing page.
Minimum interior cabinet depth: 24” (61.0 cm)
•  Install the junction box in a location that allows the 
oven to be removed from the cutout for service without 
being disconnected.
•  Plan the installation so that all minimum clearances are 
met or exceeded. Dimensions shown provide minimum 
clearances, unless otherwise noted. Be certain that 
proper clearance is provided for the oven door when 
it is in the open position according to the Product 
Dimensions.
•  Cabinet cutout dimensions must be used as indicated. 
The specified minimum cabinet depth and width must 
be provided. The cabinet depth and width must com-
pletely enclose the recessed portion of the oven.
•  All contact surfaces between the appliance and the 
cabinet must be solid and level. 
•  Provide a platform within the cabinet to support the 
oven. It must be installed level and straight. The top 
edge of the platform must be flush with the cutout at 
the front of the cabinet. There are no provisions to level 
the oven after it has been installed. 3/4” (1.9 cm) thick 
plywood is recommended.
Cabinet Dimensions
Cabinet tolerances: +1/16 (1.6 mm), -0, unless otherwise stated.
Model 
Number
 (N) Minimum 
Cabinet Width
 (P) Cutout Width
 (R) Minimum 
Cutout Height
RNO(V)127
27” (68.6 cm)
25 1/2” (64.8 cm) 
minimum (recommended) 
26 1/8” (66.4 cm)
maximum
27 1/2”
(69.9 cm) 
RNO(V)130
30” (76.2 cm)
28 1/2” (72.4 cm)
minimum (recommended)
29 1/8” (74.0 cm)
maximum
RNO(V)227
27” (68.6 cm)
25 1/2” (64.8 cm) 
minimum (recommended) 
26 1/8” (66.4 cm)
maximum
49 7/8”
(126.7 cm)
RNO(V)230
30” (76.2 cm)
28 1/2” (72.4 cm)
minimum (recommended)
29 1/8” (74.0 cm)
maximum