GE GTD81GS 설치 설명서

3

Keep flammable materials and vapors, such as gasoline, 

away from dryer.
Place dryer at least 18” (46 cm) above the floor for a 

garage installation.
Failure to do so can result in death, explosion, or fire.

•

 

Installation must conform to the 

MANUFACTURED HOME CONSTRUCTION AND 

SAFETY STANDARD, TITLE 24, PART 32–80 or 

Standard CAN/CSA-Z240 MH, or, when such 

standard is not applicable, with AMERICAN 

NATIONAL STANDARD FOR MOBILE HOME,  

ANSI/NFPA NO. 501B.

•

 

The dryer MUST be vented to the outdoors. The 

exhaust vent must be securely fastened to a 

non-combustible portion of the mobile home.

•

 

The vent MUST NOT be terminated beneath a 

mobile or manufactured home.

•

 

The vent duct material MUST BE METAL.

•

 

KIT 14-D346-33 MUST be used to attach the dryer 

securely to the structure.

•

 

The vent MUST NOT be connected to any other 

duct, vent or chimney.

•

 

Do not use sheet metal screws or other 

fastening devices which extend into the interior 

of the exhaust vent.

•

 

Provide an opening with a free area of at least 

25 square inches for introduction of outside air 

into the dryer room.

•

 

See the sections for electrical connection 

information. 

•

 

If the dryer is approved for installation in an 

alcove or closet, it will be stated on a label on the 

dryer back.

•

 

The dryer MUST be vented to the outdoors. See 

the EXHAUSTING THE DRYER section.

•

 

Minimum clearance between dryer cabinet and 

adjacent walls or other surfaces is:

    0” 

either 

side

    3” 

front

    3” 

rear

•

 

Minimum vertical space from dryer to overhead 

shelves, cabinets, ceilings, etc., is 1” on top.

•

 

Consideration must be given to provide adequate 

clearance for installation and service.

•

 

Closet doors must be louvered or otherwise 

ventilated and have at least 60 square inches of 

open area. If the closet contains both a washer 

and a dryer, doors must contain a minimum of 

120 square inches of open area.

NOTE:  WHEN THE EXHAUST DUCT IS LOCATED IN 

THE REAR OF THE DRYER, THE CONFIGURATION OF 

THE DUCTING MAY REQUIRE GREATER THAN 3” OF 

REAR CLEARANCE.

GE strongly recommends the use of factory specified parts. 

Select the power cord to fit your installation requirements.
Order on-line at GEApplianceParts.com, 24 hours a day or  

by phone at 800.626.2002 during normal business hours.

WX9X2

3-Prong

4 Feet

30

WX9X3

3-Prong

5 Feet

30

WX9X4

3-Prong

6 Feet

30

WX9X18

4-Prong

4 Feet

30

WX9X19

4-Prong

5 Feet

30

WX9X20

4-Prong

6 Feet

30

Minimum clearance to combustible surfaces and 

for air opening are: 0” both sides, 1” front and 

3” rear. Consideration must be given to provide 

adequate clearance for installation and service.