Marvel ML24WD 사용자 설명서

다운로드
페이지 24
10
Power Failure
ALARM RESET
Upper/Lower
zones
(Dual Zone
models only)
Turning your appliance ON and OFF (Single 
and Dual Zone):
If the appliance is "On", (and out of sleep mode) the tem-
perature will be shown in the display area of the control. 
To turn the appliance "Off", press and hold the "On/Off" 
keypad for 4-seconds. "OFF" will now be displayed on the 
control.
To turn the appliance "On", press and hold the "On/Off" 
keypad for 4-seconds.
The sleep mode can be disabled if you prefer to have the 
display on continuously. Press and hold the "Lock" key-
pad until the display goes past "Loc" and reads "nSL". To 
enable the sleep mode, repeat the instruction, again going 
past "Loc" until the display reads "SLP".
To wake the display press any keypad. A confirm tone will 
sound, and the current storage compartment temperature 
will be displayed. 
Sleep mode (Single and Dual Zone):
If no keypads are pressed for 60 seconds, the display will 
enter sleep mode to conserve power. The control panel will 
go dark with the exception of the system status "OK" indi-
cator which will remain enabled. Alarm conditions will wake 
the display, (see alarms on page 12).
To make the following changes to the control settings 
(turning the appliance ON/OFF, adjusting the tempera-
ture, changing the interior lights, and activating vaca-
tion mode), the control must be awake. 
Starting your appliance (Single and Dual 
Zone:
Plug the appliance power cord into a 115 volt wall outlet. 
Your appliance is shipped from the factory in the "On" posi-
tion and will begin start-up of cooling as soon as power is 
supplied. If the appliance does not start, confirm that the 
wall outlet has power, and that the control is in the "On" 
position, (See "Turning your appliance On and Off" below). 
The control display is covered with a clear plastic film. This 
film may be removed by carefully lifting the film at a corner.
On initial power up, the control display will indicate a 
"Power Failure" alarm. This is a normal condition as the ap-
pliance was powered-up at the factory for quality inspection 
and then removed from power. A momentary press of the 
"On/Off" keypad will reset this alarm condition. (See Alarms 
section on page 12).
USING YOUR ELECTRONIC CONTROL
Figure 9
Electronic control
Temp
Minus
keypad
Temp
Plus
keypad
On/Off
keypad
Display Area
Lights keypad
(glass door
only)
Lock
keypad
System Status
indicators