Marvel ML24WD 사용자 설명서

다운로드
페이지 24
14
!
CAUTION
!
WARNING
Cabinet 
"Z" Bracket
!
WARNING
Use extreme caution with the articulated hinges. The 
hinge is self closing and many pinch points exist prior 
to built-in installation. 
Do not remove the cabinet "Z" 
bracket from the top of the cabinet.
!
WARNING
The articulated hinges have many pinch points. Care-
fully close / collapse the hinges as soon as the door is 
removed from the cabinet.
Loosen (do not remove ) these 
2 phillips head screws on the 
top and bottom hinges
Figure 10a
Figure 10
"P" clamp 
and screw
Wire connector
see Figure 11
Figure 10b
Bottom of
door
OVERLAY DOOR PANEL INSTALLATION
If you purchased an overlay panel model, your unit is 
equipped with articulated hinges to allow fully integrated 
built-in installations. Custom panel thicknesses of 
5
8
" (15 
mm) and 
3
4
" (18 mm) are accommodated.
It is important to use the factory provided grille that came 
with the product to assure proper air flow is maintained 
through the condenser. The use of a custom grille is not 
recommended and will void the warranty.
Overlay panel models are designed for use with 
built-
in installations only. Use in freestanding installations 
could result in personal injury.
Step 1: Removing the Door
With a phillips screwdriver remove the screw and "P" clamp 
from the bottom of the door near the hinge. See Figure 10b.
Disconnect the door wire harness by pressing and holding 
down the locking tab on the wire connector and pulling the 
connector apart. See Figure 11.
Open the door and loosen the screws holding the hinges to 
the cabinet (2 at the top and 2 at the bottom hinge). Do not 
remove the screws but loosen them enough so the hinges 
can be slipped off of the screws when sliding the door to 
the side.
With a helper, and being careful not to scratch the cabinet 
or the door, slide the door to the side about 
1
2
 inch and 
remove the hinges and door from the unit.
Step 2: Remove the door gasket
With the door laying on a flat surface and starting at a 
corner of the door remove the magnetic door gasket from 
the interior side of the door, see Figure 12. Set the gasket 
aside on a flat surface.
There are 10 holes in the gasket retainer extrusions, (3 on 
each side and 2 at the top and bottom which are used to 
fasten the panel to the front of the door. The screws are 
provided in the literature pack.