GE JGP333DETWW 설치 설명서
15
Installation Instructions
E Install the LP/Propane orifices in their precise
locations as noted in the illustrations above.
F Return the natural gas orifices to the bracket
and reattach the bracket and the instruction
sheet to the pressure regulator using the
screw removed previously.
G Replace the burner bases, heads, caps and
top grates. (NOTE: When re-attaching the
burner bases to glass top units, tighten screws
to a maximum of 10 in.-lbs torque.)
3 CHANGE COOKTOP BURNER
ORIFICES (CONT.)
D Locate the LP/Propane orifices shipped
inside the literature package. They
will have a digit number and the letter “L” on
the side. (Important: Save the orifices
removed from the appliance
for future use.)
Each orifice will show a series of engraved
marks, (I, II, III, X or none),
located on the top.
These marks denote the precise location of each
orifice to the cooktop burner.
15,000 BTU/HR Burner
(on some models)
NOTE: The main orifice is located low in the center
of the burner while the simmer orifice is located
higher behind the center of the burner.
I
II
III
X
The 15,000 BTU/HR burner has two orifices with
markings located in the sides only. (See rating
plate on bottom of appliance).
I
II
III
X
Main orifice
Simmer
orifice
See
table
See
table
See
table
Model Rear Left
Burner
Front Left
Burner
Front Right
Burner
JGP329
II
II
III
JGP940
III
III
X
JGP333
PGP943
III
II
Replace: With:
Main 175HXN ➔ 99HXL
Simmer 57N ➔ 34L