Vinotemp VTOUTDOORREF 사용자 매뉴얼

12 

 

 

 
Most common problems can be solved easily, saving you the cost of a possible service 
call. Try the following suggestions to see if you can solve the problem before 
contacting Vinotemp at info@vinotemp.com.  

 

The unit does not operate 

•  Ensure unit is plugged in to electrical outlet. 
•  Check if unit is turned off. 
•  Check for a tripped circuit breaker or blown fuse. 

The unit is not cold 
enough 

•  Check the temperature control setting. 
•  External environment or ambient temperature may require a 

higher setting. 

•  Check if door does not close completely or is open too often. 
•  Check if door gasket does not seal properly.  

The unit turns on and off 
frequently 

•  The room temperature may be hotter than normal.  
•  Check if door does not close completely or is open too often. 
•  Check if door gasket does not seal properly. 
•  The temperature control is not set correctly.   

The unit light does not 
work 

•  Ensure unit is properly plugged in. 
•  Check for a tripped circuit breaker or blown fuse.  
•  Check if the light switch is OFF.  

The unit makes too much 

noise or vibrates 

•  Check to ensure the unit is level. 
•  The rattling noise may come from the flow of refrigerant. 

This is normal.  

•  As each cycle ends, you may hear gurgling sounds caused 

by the flow of refrigerant in the unit. This is normal.  

•  Contraction and expansion of the inside walls may cause 

popping and crackling noises.  

The unit door will not 
close properly 

•  Check to ensure the unit is level.  
•  The door was reversed and was not properly installed. 
•  The gasket is dirty. 
•  The shelves are out of position.  

Display shows “EL” or 
“EH” 

•  The air temperature sensor has failed.