Vinotemp VTOUTDOORREF 사용자 매뉴얼
8
W W W . V I N O T E M P . C O M
INSTALLATION
• Remove all packing material before using your appliance.
• IMPORTANT: Before connecting the unit to a power source, let it stand upright for
• IMPORTANT: Before connecting the unit to a power source, let it stand upright for
approximately 24 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
• Clean the interior surface with lukewarm water and a soft cloth.
• This unit is designed for freestanding or built in installation and indoor or outdoor use.
• This unit is designed for freestanding or built in installation and indoor or outdoor use.
Position the unit in a dry and well-ventilated place. Avoid placing the unit near any source
of heat or moisture, or in direct sunlight. Do NOT install the unit in a location with an
ambient temperature that will fall below 44°F.
• For freestanding installation, 5 inches of space between the back and sides of the unit are
suggested, which allows the proper air circulation to cool the compressor and condenser for
energy saving. Even for built-in installation, it is a must to keep ¼” space on each side and
at the top to ensure proper service access and ventilation. And the air vent at the front of
the appliance must never be covered or blocked in any way.
• Place the unit on a level surface strong enough to support it when it is fully loaded. To
level the appliance, adjust the front leveling legs at the bottom of the appliance.
• For best performance it is recommended that you install the appliance in a location with
an ambient temperature between 44°-106°F. If the ambient temperature is above or
below recommended temperatures, the performance of the unit may be affected.
OPERATING YOUR WINE COOLER
CONTROLS
c
F
Temp.
Power
To turn the appliance ON or OFF, touch the
for 5 seconds.
Light
Turn the interior light ON or OFF.
Up
Raise the set temperature by 1°C or 1°F.
Down
Lower the set temperature by 1°C or 1°F.
ºF/ºC Selector
Choose to display temperature setting in Fahrenheit or Celsius. To change the temperature
display from Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold for 5
seconds.
display from Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold for 5
seconds.