KitchenAid KDTE254EWH 사용자 매뉴얼

Dishwasher Feedback Section

1. Open the door slightly to stop the cycle. Wait for the spraying 

action to stop before completely opening the door. 

2. Press and hold CANCEL/DRAIN button once. The Cancel/

Drain light will light up.

3. Close the door and the dishwasher starts a drain cycle (if water 

remains in bottom of dishwasher). Let the dishwasher drain 
completely. The Cancel/Drain light turns off after 2 minutes.

1. You can interrupt a cycle and restart your dishwasher from 

the beginning using the following procedure.

2. Open the door slightly to stop the cycle. Wait for the spraying 

action to stop, then open the door completely. 

3. Check that detergent dispenser cover is still closed. If cover 

is open, you will need to refill the detergent dispenser before 
restarting your new cycle.

To start or resume 
a wash cycle

If the door is opened during a cycle for any reason or if the power is interrupted, the 
Start/Resume indicator flashes. The cycle will not resume until the Start/Resume button 
is pressed and the door is closed.

NOTE: (for models with controls on top of the door) Push door firmly closed within 
3 seconds of pressing Start/Resume. If the door is not closed within 3 seconds, the 
Start/Resume light will flash, an audible tone will be heard, and the cycle will not start.

To reset any cycle 
or options during 
selection or to cancel 
a wash cycle after it's 
started.

Press CANCEL/DRAIN to reset any control selections made.

IMPORTANT: Your model may indicate that you press and hold the button for up 
to 3 seconds to initiate the cancel. The Cancel light will turn on and all other cycle 
and option lights will turn off when Cancel is active.

See the “Canceling A Cycle” and “Changing A Cycle After Dishwasher Is Started” 
sections.

To turn the audible 
tones on or off.

Press and hold the HI TEMP WASH button for 3 seconds to turn the audible tones on 
or off. Only audible tones for confirming button presses can be turned on/off. Important 
audible tones, such as indicating a cycle has been interrupted, cannot be deactivated.  

The Cycle Status 
Indicator Light is 
used to follow the 
progress of the 
dishwasher cycle. 
It is located on the 
front of the door.

The single indicator light on the front of the door panel (A) will remain blue 
during wash/rinse, red during dry, and white when complete.

The Cycle Status 
Display is used to 
follow the progress 
of the dishwasher 
cycle, and to show 
other information. 

The Time Display is used for estimated cycle time and also for delay hours. 

Estimated cycle time is displayed in hours and minutes as you make cycle 
and option selections. After you start the dishwasher, the display counts 
down the time. 

After you press the Start/Resume button, the Time Display counts down 
seconds to close the door. If the door is not closed by the end of the 
countdown you will hear a series of beeps and the cycle will not start.

When you select the Delay feature, the Time Display will give the number 
of hours followed by an “H”. 

A