Siemens WLAN Repeater 108 S30853-H1030-R701 사용자 설명서

Gigaset WLAN Repeater 108 / englisch / A31008-M1030-B101-3x-7619 / appendix.fm / 06.11.2008

Te

m

plat

e 20

05_0

5_02

If your device does not function as it should, use the following table to try to remedy the 
problem.
Additional solutions to problems are already available on our Customer Care page. 
Visit our Service page at www.gigaset.com/customercare.

No LED lights up on 
the front panel. 

The device is not 
correctly connected 
to the mains power 
supply.

ì

Check whether the mains adapter 
plug is properly inserted in the 
device. 

ì

Check whether the socket in which 
the mains adapter is plugged is live. 
This can be done using a device that 
you know works properly, e.g. a 
desk lamp. 

The LED for the 
Gigaset WLAN 
Repeater 108 LAN 
socket does not 
light up.

You do not have any 
devices connected.

ì

Connect a device using the LAN 
cable supplied.

The device has not 
been properly 
connected.

ì

Make sure that the LAN cable 
connectors sit firmly in the correct 
connection sockets on both the 
Gigaset WLAN Repeater 108 and the 
connected terminal.

Your Gigaset WLAN 
Repeater 108 is not 
connected to the 
mains power supply 
or is not ready for 
use.

ì

Check whether the Power LED on 
your Gigaset WLAN Repeater 108 is 
continuously lit and, if appropriate, 
restart your Gigaset WLAN Repeater 
108 by briefly disconnecting it from 
the mains power supply.

The connected device 
is not switched on or 
not ready for use.

ì

Check the status of the connected 
device and, if appropriate, restart it.

You are not using the 
correct cable or the 
cable is damaged.

ì

Connect the device with the sup-
plied cable or an Ethernet or Crosso-
ver cable, category 5 or higher. Try 
replacing the cable with one of the 
same type. ISDN cables or other 
cables with RJ45 connectors are not 
suitable for the connection.