HP (Hewlett-Packard) 45000 전단
HP Designjet 35000/45000 Printer series
Unpacking and Assembly Instructions
Unpacking and Assembly Instructions
2
Connect cables
4
Switch on the power
5
Remove carriage restraints
1
Unpack
3
Remove shipping restraints
1.
Cut the steel shipping bands from the shipping container.
2.
Remove the lid and shipping box from the pallet.
3.
Remove the packing material from around the outside of the
printer.
printer.
4.
Locate the inks and the accessory kit box, on the shelf at the
right rear side of the printer. Remove and set aside.
right rear side of the printer. Remove and set aside.
5.
Remove the starter media and set aside.
6.
Using a ½-inch (13 mm) socket wrench, remove the four bolts
that attach the end plate to the pallet. Remove the end plate and
set aside.
that attach the end plate to the pallet. Remove the end plate and
set aside.
7.
Remove the pallet ramps from the pallet, and attach them as
shown using two of the bolts from the previous step.
shown using two of the bolts from the previous step.
8.
Remove the bolts that attach the
printer to the pallet, and the bolts
that attach the L-shaped shipping
brackets to the printer (4 places).
printer to the pallet, and the bolts
that attach the L-shaped shipping
brackets to the printer (4 places).
9.
Unlock the casters
(4 places).
(4 places).
10. Carefully roll
the printer
on its casters
off the pallet
and down
the ramps.
on its casters
off the pallet
and down
the ramps.
16 mm
13 mm
Bolt here
Bolt here
To power (220V AC)
Auxiliary power (24V DC)
(optional, see manual)
(optional, see manual)
VideoNet to RIP
To optional foot switch
Power On/Standby switch
Remove the bright colored tape from the media edge holders
(on the platen).
(on the platen).
Reach inside the left cover to cut the plastic restraining band
from the service station, and remove the band with attached
cardboard spacer.
from the service station, and remove the band with attached
cardboard spacer.
Cut the zip ties holding the light blocker at the front of the
platen, and lower it into operating position.
platen, and lower it into operating position.
Cut and remove zip ties and tape from the input and output
tables (rear and front of the printer), and from the adjustable
fence (rear of the printer).
tables (rear and front of the printer), and from the adjustable
fence (rear of the printer).
Cut and remove the shipping band that secures the service
station, and completely remove it from the printer.
station, and completely remove it from the printer.
Do not attempt to remove the carriage shipping restraints until
Step 5.
Step 5.
Press the power switch on the back of the printer to the On position.
The printer control panel will walk you through removing the shipping
restraints from the printhead carriage (see Step 5).
The printer control panel will walk you through removing the shipping
restraints from the printhead carriage (see Step 5).
Ê
With th
loosen
four
left and right
e included L-shaped hex key,
the
screws on
the
arms, and pull the arms straight out from the
carriage.
Ì
Ê
Locate the cables in the accessory box, and connect as shown:
Continued on next page