Netopia R2020 사용자 설명서

The following is a quick guide to configuring TCP/IP for MacOS computers. Configuring TCP/IP in a Macintosh 
computer requires the following:

■

You must have either Open Transpor t or Classic Networking (MacTCP) installed.

Note: If you want to use the Dynamic Host Configuration Protocol (DHCP) ser ver built into your Netopia 
R2020 to assign IP addresses to your Macintoshes, you must be running Open Transpor t, standard in 
MacOS 8, and optional in earlier system versions. You can have your Netopia R2020 dynamically assign IP 
addresses using MacTCP; however, to do so requires that the optional AppleTalk kit be installed which can 
only be done after the router is configured.

■

You must have built-in Ethernet or a third-par ty Ethernet card and its associated drivers installed in your 
Macintosh.

If you configure your Netopia R2020 using Smar tStar t, you can accept the dynamic IP address assigned by your 
router. The Dynamic Host Configuration Protocol (DHCP), which enables dynamic addressing, is enabled by 
default in the router. To configure your Macintosh computer for dynamic addressing do the following:

Note: You can also use these instructions to configure other computers on your network to accept IP addresses 
ser ved by the Netopia R2020.

1.

Go to the Apple menu. Select Control Panels and then 
TCP/IP.

2.

With the TCP/IP window open, go to the Edit menu and 
select User Mode. Choose Basic and click OK.

3.

In the TCP/IP window, select “Connect via: Ethernet” and 
“Configure: Using DHCP Ser ver.”