Denon AVR-2312CI 사용자 설명서
65
1
Set up the
remote control unit
n Set up the zone mode
Press
ZONE SELECT
to switch the zone mode to
J
(MAIN ZONE).
The
J
indicator lights.
Press ZONE SELECT
n Set up the operation mode
Press
AMP
to set the remote control unit to AMP-
operation mode.
Press AMP
2
Connect the setup microphone.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Amp Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the
to the
recommendations in the manual.
Set the following items
If necessary.
Start Auto Setup
Enter
Cancel
When the setup microphone is
connected, the following screen is
displayed.
connected, the following screen is
displayed.
Set up speakers
around items indicate the settings.
Here we describe how to set up speakers other than 5.1-channel speakers.
For the method of setting up 5.1-channel speakers, see
For the method of setting up 5.1-channel speakers, see
C
page 4 “SETUP WIZARD”
.
First install and connect the speakers to this unit.
Before Auto Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Amp Assign)
• Changing the amplifier assignment (Amp Assign)
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (
3
Set up “Amp Assign”
Use
ui
to select “Amp Assign”, and then press
ENTER
.
AMP ASSIGN
[1/2]
RETURN
Assign Mode ZONE2
Assign power amp to ZONE2 stereo signal
Return
ZONE2:
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Amp Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the
to the
recommendations in the manual,
Set the following items
If necessary.
Change assigned power amp to match the speaker system
Enter
Cancel
Basic v
ersion
A
dv
anced v
ersion
Inf
or
or
mation
A
dv
anced v
ersion
vSee overleaf