AOC A42W64AT4 사용자 설명서
1
Read before operating equipment
1. Read and follow all instructions.
2. Do not operate this apparatus near water.
3. Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
4. Do not block any of the ventilation openings.
5. Clean only with a dry cloth.
6. Do not defeat the safety purpose of the polarized or grounding-type
5. Clean only with a dry cloth.
6. Do not defeat the safety purpose of the polarized or grounding-type
plug. .A polarized plug has two blades with one wider than the other. A
grounding type plug has two blades and third grounding prong. The
wide blade or third prong are provided for your safety. When the
provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet..
grounding type plug has two blades and third grounding prong. The
wide blade or third prong are provided for your safety. When the
provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet..
7. Protect the power cord from being walked on or pinched particularly at
plugs, convenience receptacles, and the point where they exit from the
apparatus.
apparatus.
8. Only use attachments/accessories specified by the manufacturer.
9. Use only with a cart, stand, tripod, bracket, or table specified by the
9. Use only with a cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving
the cart/apparatus combination to avoid injury from tip-over.
the cart/apparatus combination to avoid injury from tip-over.
10. Unplug this apparatus during lightning storms or when
unused for long periods of time.
11. Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as
power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or has been dropped.
power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or has been dropped.
12. This product may contain lead and mercury. Disposal of these
materials may be regulated due to environmental considerations. For
disposal or recycling information, please contact your local authorities
or the Electronic Industries Alliance: www.eiae.org
disposal or recycling information, please contact your local authorities
or the Electronic Industries Alliance: www.eiae.org
13. Damage Requiring Service -The appliance should be serviced by
qualified service personnel when:
•
The power supply cord or the plug has been damaged; or
•
Objects have fallen, or liquid has been spilled into the appliance;
or
or
•
The appliance has been exposed to rain; or
•
The appliance does not appear to operate normally or exhibits a
marked change in performance; or
marked change in performance; or
•
The appliance has been dropped, or the enclosure damaged.
14. Tilt/Stability- All televisions must comply with recommended
international safety standards for tilt and stability properties of its
cabinet design.
cabinet design.
•
Do not compromise these design standards by applying
excessive pull force to the front, or top, of the cabinet which
could ultimately overturn the product.
excessive pull force to the front, or top, of the cabinet which
could ultimately overturn the product.
•
Do not endanger yourself, or children, by placing electronic
equipment/toys on the top of the cabinet. Such items could
unsuspectingly fall from the top of the set and cause product
damage and/or personal injury.
equipment/toys on the top of the cabinet. Such items could
unsuspectingly fall from the top of the set and cause product
damage and/or personal injury.
15. Wall or Ceiling Mounting- The appliance should be mounted to a wall
or ceiling only as recommended by the manufacturer.
16. Power Lines- An outdoor antenna should be located away from power
lines.
17. Outdoor Antenna Grounding- If an outside antenna is connected to
the receiver, make sure the antenna system is grounded so as to
provide protection against voltage surges and built up of static
charges.
Section 810 of the National Electric Code, ANSI/NFPA No.70-1984,
provides information with respect to proper grounding of the mast and
supporting structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding connectors, location of
antenna-discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode. See Figure below.
provide protection against voltage surges and built up of static
charges.
Section 810 of the National Electric Code, ANSI/NFPA No.70-1984,
provides information with respect to proper grounding of the mast and
supporting structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding connectors, location of
antenna-discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode. See Figure below.
18. Object and Liquid Entry- Care should be taken so that objects do not
fall and liquids are not spilled into the enclosure through openings.
19. Battery Usage CAUTION –To prevent battery leakage that may result
in bodily injury, property damage, or damage to the unit:
•
Install all batteries correctly, with + and - aligned as marked on
the unit.
the unit.
•
Do not mix batteries (old and new or carbon and alkaline, etc.).
•
Remove batteries when the unit is not used for a long time.
20. Keep this manual for future reference
Note to the CATV system installer: This
reminder is provided to call the CATV
system installer's attention to Article 820-40
of the NEC that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of the
building, as close to the point of cable entry
as practical.
reminder is provided to call the CATV
system installer's attention to Article 820-40
of the NEC that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of the
building, as close to the point of cable entry
as practical.
IMPORTANT SAFETY INSTRUCTIONS
Example of Antenna Grounding as per
NEC - National Electric Code
NEC - National Electric Code
(NEC SECTION 810-20)
(NEC SECTION 810-21)
ANTENNA LEAD IN WIRE
ANTENNA DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING ELECTRODE SYSTEM
(NEC ART 250, PART H)
GROUND CLAMP
ELECTRIC SERVICE EQUIPMENT