DKS Enterprises 1803PC 사용자 설명서
3.5.5 Programming Names (1815, 1817 Systems Only)
In this section, names will be programmed into the system. Names are referenced to a phone
number by entering the directory code that the persons phone number has been programmed to.
number by entering the directory code that the persons phone number has been programmed to.
1.
Press *66 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2.
Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.5.1) then press * (beep).
3.5.1) then press * (beep).
3.
Begin entering the residents name one character at a time as described on page 30.
When the desired character (letter, number or space) is displayed, press * to enter
that character.
When the desired character (letter, number or space) is displayed, press * to enter
that character.
4.
Repeat step 3 to enter additional characters until the desired name is displayed in the
directory. NOTE 1: 15 characters maximum. NOTE 2: If you make a mistake in steps
4 or 5, press # to clear the display and start over.
directory. NOTE 1: 15 characters maximum. NOTE 2: If you make a mistake in steps
4 or 5, press # to clear the display and start over.
5.
After the last character has been entered, press * (beep) to enter the complete name.
The display will be blank.
The display will be blank.
6.
Repeat steps 2, 3, 4, and 5 to enter additional names.
7.
Press 0# TOGETHER to end this programming step (beeeeeep).
3.5.6 Deleting Individual Phone Numbers
This programming sequence is used to delete a single phone number under a known directory code.
Proceed to 3.5.7 to delete the resident name.
Proceed to 3.5.7 to delete the resident name.
1.
Press *01 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2.
Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.5.1) then press * (beep).
3.5.1) then press * (beep).
3.
Press # # # # # # # then press * (beep).
4.
Repeat steps 2 and 3 to delete additional phone numbers.
5.
Press 0# TOGETHER to end this programming step (beeeeeep).
3.5.7 Delete Names (1815, 1817 Systems Only)
This programming sequence is used to delete a resident name from the directory. These steps will
not erase the resident telephone number from the system. Go to section 3.5.6 to delete the resident
telephone number.
not erase the resident telephone number from the system. Go to section 3.5.6 to delete the resident
telephone number.
1.
Press *65 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2.
Use the A and Z buttons to locate the name that is to be erased, then press * (beep).
3.
Repeat step 2 to erase additional names.
4.
Press 0# TOGETHER to end this programming step (beeeeeep).
45