Pioneer DBR-T200GB Manual Do Utilizador
10
<BRB1056>
The remote controller not only operates the digital receiver but can also control the main functions
of major brand TVs and VCRs. Refer to page 50 for programming instructions.
of major brand TVs and VCRs. Refer to page 50 for programming instructions.
Putting Batteries in the
Remote Controller
Remote Controller
CAUTION
• Do not mix new and used batteries. Only add
all new batteries.
• Do not mix battery brands. Different battery
brands may have different voltages even if the
same size.
same size.
• When not planning to use the remote control-
ler for a long period of time (over one month),
remove the batteries to prevent battery fluid
leaks inside the remote controller. If a battery
leak occurs inside the remote controller, dis-
card the old batteries, wipe out the liquid from
the case, and add new batteries.
remove the batteries to prevent battery fluid
leaks inside the remote controller. If a battery
leak occurs inside the remote controller, dis-
card the old batteries, wipe out the liquid from
the case, and add new batteries.
• The PIONEER batteries supplied with the re-
mote controller do not contain heavy metals,
such as mercury, nickel, or cadmium. In many
countries, however, the disposal of batteries
with household waste is not allowed. Be sure
to comply with local regulations when dispos-
ing of batteries.
such as mercury, nickel, or cadmium. In many
countries, however, the disposal of batteries
with household waste is not allowed. Be sure
to comply with local regulations when dispos-
ing of batteries.
• The remote controller's brand code setting
will only last for about one minute, so to pre-
vent the inconvenience of losing the stored
settings, have ready a fresh set of new bat-
teries and add them immediately after remov-
ing the old batteries. However, if the remote
controller's buttons are pressed while the
batteries are removed, the brand code setting
will be deleted. Please be careful not to press
the buttons while replacing the batteries.
vent the inconvenience of losing the stored
settings, have ready a fresh set of new bat-
teries and add them immediately after remov-
ing the old batteries. However, if the remote
controller's buttons are pressed while the
batteries are removed, the brand code setting
will be deleted. Please be careful not to press
the buttons while replacing the batteries.
Caring for the Remote Controller
• Do not drop the remote controller.
• Do not get the remote controller wet.
• Do not use or store the remote controller in
• Do not drop the remote controller.
• Do not get the remote controller wet.
• Do not use or store the remote controller in
the following locations:
In direct sunlight
Near hot objects
Areas with high humidity
In direct sunlight
Near hot objects
Areas with high humidity
• If an object is blocking the path between the
remote controller and the ONdigital box sig-
nal sensor the unit might not respond to the
remote controller commands. If this happens,
remove the obstacle or change your position.
nal sensor the unit might not respond to the
remote controller commands. If this happens,
remove the obstacle or change your position.
• As the batteries weaken, the range of the re-
mote controller becomes shorter. If the opera-
tion range is too short for your preference,
replace the batteries.
tion range is too short for your preference,
replace the batteries.
Remote Controller Operation
Range
Range
OPERATION PANEL FEATURES AND FUNCTIONS
To add or change the batteries,
slide open the battery
compartment cover on the back of
the remote controller by pushing it
down and sliding it open.
slide open the battery
compartment cover on the back of
the remote controller by pushing it
down and sliding it open.
Add two new
AA batteries.
AA batteries.
digital
DIGIT
AL TERRESTRIAL
RECEIVER
SURROUND
SMAR
T CARD
MENU
SELECT
ON/OFF