Pioneer DBR-T200GB Manual Do Utilizador
51
<BRB1056>
The remote controller can directly control the televisions and VCRs of other major brands. When
the remote controller power is first turned on it is programmed for PIONEER brand TVs and VCRs,
but if you will use a TV or VCR of another major brand, follow the instruction below to setup the
remote controller.
the remote controller power is first turned on it is programmed for PIONEER brand TVs and VCRs,
but if you will use a TV or VCR of another major brand, follow the instruction below to setup the
remote controller.
USING REMOTE CONTROLLER WITH EQUIPMENT OF OTHER MANUFACTURERS
TV ID code setup
This is used for TVs only.
Resetting the remote controller to the default settings
If necessary, the remote controller can be reset to the factory default settings by clearing all of the
programmed codes.
To do this, press code 9999 while pressing and holding the remote controller button. This re-
stores all devices to their default settings.
programmed codes.
To do this, press code 9999 while pressing and holding the remote controller button. This re-
stores all devices to their default settings.
Status during battery replacement
The remote control information preservation time during battery replacement is about 1 minute.
The buttons will not respond while the batteries are being replaced. When the batteries have been
dead or removed for more than 1 minute the brand settings will return to their default values.
The buttons will not respond while the batteries are being replaced. When the batteries have been
dead or removed for more than 1 minute the brand settings will return to their default values.
IMPORTANT:
Although the PIONEER remote controller is compatible with most major brands, PIONEER can-
not guarantee the remote controller operation will be compatible with all TV's or VCR's.
not guarantee the remote controller operation will be compatible with all TV's or VCR's.
Press and hold down the remote controller
but-
ton for TV at the bottom right while entering the
4-digit code for the brand of the TV being used.
(Refer to the included code list.)
4-digit code for the brand of the TV being used.
(Refer to the included code list.)
Press the
button to check if the remote controller can be used to
turn on the TV and put it in standby.
IMPORTANT:
It might not be possible to use the remote controller to directly
control some TVs.
control some TVs.
VCR ID code setup
This is used for VCR only.
Press and hold down the remote controller
but-
ton for VCR at the bottom left while entering the
4-digit code for the brand of the VCR being used.
(Refer to the included code list.)
4-digit code for the brand of the VCR being used.
(Refer to the included code list.)
Press the
button to check if the remote controller can be used to
turn on the VCR and put it in standby.
IMPORTANT:
It might not be possible to use the remote controller to directly
control some VCRs.
control some VCRs.
CAUTION
• When setting the brand code, ensure not to direct the remote controller to any other TVs, VCRs
and so forth, because there is always a possibility that such equipment on hand may be oper-
ated.
ated.