Datalogic Scanning D8330 Manual Do Utilizador
MESSAGE FORMATTING
173
• The cursor row position is not affected by the currently selected font. The
display always has 4 rows, so when writing with the large font, actually two rows
are written to: the current one and the one below it. You will need two ESC E
commands to step from one row to the next when using the large font.
are written to: the current one and the one below it. You will need two ESC E
commands to step from one row to the next when using the large font.
• The cursor column position is affected by the currently selected font. Therefore,
column 6 is 36 pixels from the left border only if you last selected the 6x8 font;
otherwise it could be 48 or 72 pixels from the left border.
otherwise it could be 48 or 72 pixels from the left border.
6.1.2
Font Selection
ESC [ 0 m
Normal mode
ESC [ 7 m
Reverse mode
ESC # 4
Large font: subsequent characters are written on the current row and
the row below it using the 12x16 font which allows for two rows of
eight characters on the display.
the row below it using the 12x16 font which allows for two rows of
eight characters on the display.
ESC # 5
Normal font: subsequent characters are written using the 6x8 font,
which allows for four rows of sixteen characters on the display.
which allows for four rows of sixteen characters on the display.
ESC # 7
Medium font: subsequent characters are written using the 8x8 font,
which allows for four rows of twelve characters on the display.
which allows for four rows of twelve characters on the display.
6.1.3
Clearing Display
ESC [ 0 K
From cursor position to end of line inclusive
ESC [ 1 K
From beginning of line to cursor position (not inclusive)
ESC [ 2 K
Entire line
ESC [ 0 J
From cursor position to end of display inclusive
ESC [ 1 J
From beginning of display to cursor position (not inclusive)
ESC [ 2 J
Entire display; moves cursor to upper left corner on display
6.1.4
LED and Beeper Control
ESC [ 0 q
Emit short High tone + short delay
ESC [ 1 q
Emit short Low tone + short delay
ESC [ 2 q
Emit long Low tone + short delay
ESC [ 3 q
Emit good read tone
ESC [ 4 q
Emit bad tx tone
ESC [ 5 q
Wait 100 ms
ESC [ 6 q
Turn on the green LED
ESC [ 7 q
Turn off the green LED
ESC [ 8 q
Turn on the red LED
ESC [ 9 q
Turn off the red LED