Gateway CG3000 Manual Do Utilizador
Wireless Cable Voice Gateway CG3000/CG3100 User Manual
2-10
Wireless Configuration
v1.0, July 2009
specified in the Wireless Settings screen and sets the wireless security settings to either WPA-PSK
or WPA2-PSK and then and broadcasts these settings to the wireless client.
or WPA2-PSK and then and broadcasts these settings to the wireless client.
Note: NETGEAR’s Push 'N' Connect feature based on the Wi-Fi Protected Setup
(WPS) standard (for more information, see
). All other Wi-
Fi-certified and WPS-capable products should be compatible with NETGEAR
products that implement Push 'N' Connect.
products that implement Push 'N' Connect.
Some considerations regarding WPS are:
•
WPS supports only WPA-PSK and WPA2-PSK wireless security. WEP security is not
supported by WPS.
supported by WPS.
•
Before you can add a WPS client, the Security Option in the Wireless Settings screen must be
set to Disabled, WPA-PSK, or WPA2-PSK. See
set to Disabled, WPA-PSK, or WPA2-PSK. See
.
A WPS client can be added using the Push Button method or the PIN method.
•
Using the Push Button. This is the preferred method. See the following section,
.
•
Entering a PIN. For information about using the PIN method, see
Using a WPS Button to Add a WPS Client
Any wireless computer or wireless adapter that will connect to the gateway wirelessly is a client.
The client must support a WPS PIN, and must have a WPS configuration utility, such as the
NETGEAR Smart Wizard or Atheros Jumpstart.
The client must support a WPS PIN, and must have a WPS configuration utility, such as the
NETGEAR Smart Wizard or Atheros Jumpstart.
Before you can add a WPS client, the Security Option in the Wireless Settings screen must be set
to Disabled, WPA-PSK, or WPA2-PSK. See
to Disabled, WPA-PSK, or WPA2-PSK. See
To use the gateway WPS button to add a WPS client:
1. Log in to the gateway as described in
.