Gateway CG3000 Manual Do Utilizador
Wireless Cable Voice Gateway CG3000/CG3100 User Manual
2-14
Wireless Configuration
v1.0, July 2009
Adding Both WPS and Non-WPS Clients
For non-WPS clients, you cannot use the WPS setup procedures to add them to the wireless
network. You must record, and then manually enter your security settings (see
network. You must record, and then manually enter your security settings (see
To connect a combination of non-WPS enabled and WPS-Enabled clients to the gateway:
1. Restore the gateway to its factory default settings (press the Restore Factory Settings button
located on the bottom of the gateway for 7 seconds).
When the factory settings are restored, all existing wireless clients are disassociated and
disconnected from the gateway.
disconnected from the gateway.
2. Configure the network name (SSID), select either the WPA/PSK or WPA2/PSK radio button
). and click Apply. On the WPA/PSK or WPA2/PSK screen, select a
passphrase and click Apply. Record this information to add additional clients.
3. For the non-WPS devices that you want to connect, open the networking utility and follow the
utility’s instructions to enter the security settings that you selected (the SSID, WPA/PSK or
WPA2/PSK security method, and passphrase).
WPA2/PSK security method, and passphrase).
4. For the WPS devices that you want to connect, follow the procedure
The settings that you configured are broadcast to the WPS devices so that they can connect to
the gateway.
the gateway.