Philips DCB2020 Manual Do Utilizador

2

EN

1 Important

Read and understand all instructions before you 

use this product. If damage is caused by failure 

to follow the instructions, the warranty does 

not apply.

Important notes for users in 

the U.K.

Mains fuse

This information applies only to products with a 

UK mains plug.

This product is fitted with an approved non-

molded plug. If you replace the fuse, use one 

with:

•  the ratings shown on the plug,

•  a BS 1362 approval, and

•  the ASTA approval mark.

Contact your dealer if you are not sure about 

what type of fuse to use.

Caution: To conform with the EMC directive 

(2004/108/EC), do not detach the plug from 

the power cord.
How to connect a plug

The wires in the power cord are colored as 

follows: blue = neutral (N), brown = live (L).

If the colors do not correspond with the colors 

on your plug, identify the terminals in your plug 

as follows:

1 

Connect the blue wire to the terminal 

marked N or colored black. 

2 

Connect the brown wire to the terminal 

marked L or colored red.

3 

Do not connect either wire to the earth 

terminal in the plug, marked E (or e) or 

colored green (or green and yellow).

Before you replace the plug cover, make sure 

that the cord grip is clamped over the sheath 

of the cable and not just over the two wires in 

the cable.

Safety

Risk of electric shock!

•  Never expose the product and accessories 

to rain or water. Never place liquid 

containers, such as vases, near the product. 

If liquids are split on or into the product, 

disconnect it from the power outlet 

immediately. Contact Philips Consumer 

Care to have the product checked before 

use.

•  Never place the product and accessories 

near naked flames or other heat sources, 

including direct sunlight.

•  Never insert objects into the ventilation 

slots or other openings on the product.

•  Where the mains plug or an appliance 

coupler is used as the disconnect device, it 

shall remain readily operable.

•  Disconnect the product from the power 

outlet before lightning storms.

•  When you disconnect the power cord, 

always pull the plug, never the cable.

Risk of short circuit or fire!

•  Before you connect the product to the 

power outlet, make sure that the power 

voltage matches the value printed on the 

back of the product. 

•  Avoid applying pressure on the power 

plugs. Loose power plugs can cause arcing 

or fire.

Risk of injury or damage to the product!

•  To avoid exposure to laser radiation, do 

not disassemble.

•  Do not touch the optical lens inside the 

disc compartment.

•  Never place the product or any objects 

on power cords or on other electrical 

equipment.

•  If the product is transported in 

temperatures below 5°C, unpack the 

product and wait until its temperature 

matches room temperature before 

connecting it to the power outlet.