Fujifilm F700 Manual Do Utilizador

11

10

Use only the special Rechargeable Battery NP-40.
The use of other brands of rechargeable battery
could cause faults or damage to the camera.

h NP-40 Rechargeable Battery (1)

●

The battery is not fully charged at shipment and must be fully
charged before being used.

●

Do not stick labels onto the battery as this could cause the
battery to become jammed inside the camera.

●

See P.92, 93 for note on the battery.

Slide the battery cover out to open it.

●

If you open the battery cover while the camera is switched on,
the camera is switched off.

●

Do not apply excessive force to the battery cover.

Do not open the battery cover while the camera is
still switched on. This could damage the xD-
Picture Card or corrupt the image files on the xD-
Picture Card.

Hold the battery so that the arrow markings are aligned, use your finger to pull the battery
release catch in the direction shown and insert the battery. Check that the battery is firmly held
in place.

Close the battery cover.

●

The  xD-Picture Card will not slide fully into the slot if it is
inserted facing the wrong way. Be careful not to apply undue
force to the xD-Picture Card.

Align the gold mark on the xD-Picture Card slot
with the gold contact area on the xD-Picture Card
and then push the card firmly all the way into the
slot.

◆

◆

When you push the xD-Picture Card into the slot
and then slowly remove your finger, the lock is
released and the xD-Picture Card is pushed out.

◆

◆

●

The information above is an approximate guide for photography mode. In other camera modes, the transition from
“

X

” to “

V

” may occur more quickly.

●

Batteries with no remaining charge (

V

blinking red) will cause problems such as loss of power while the lens is still

extended. Always charge the battery before use.

●

Due to the nature of the battery, the battery low warning may appear early when the camera is used in cold locations.
This is normal and does not indicate a fault. Try warming the battery in your pocket or a similar location before use.

◆

◆

If the camera is not used in any way for approx. 30 seconds when the camera functions are enabled,
this function temporarily switches features such as the LCD monitor off  to reduce power consumption
(

➡.72). If the camera is then left unused for a further period (2 or 5 minutes), the Auto Power Off

function automatically switches the camera off. To switch the camera back on, set the Power switch to
“OFF” briefly and then back to “

q

” or “

w

”.

Z

, 

X

and 

C

are displayed as small icons on

the right-hand side of the LCD monitor. 

V

appears

as a large icon on the LCD monitor.

1 There is ample remaining battery charge. (Only

displayed for approximately 3 seconds when the
camera is switched on or the mode is changed.)

2 The battery is approximately half charged. (Only

displayed for approximately 3 seconds when the
camera is switched on or the mode is changed.)

3 Battery charge low. Replace or recharge the

battery as it will run out shortly.

4 The battery is exhausted. The display will shortly

go blank and the camera will stop working.
Replace or recharge the battery.

Blinking red

Lit white

Lit red

1

2

4

3

Lit white

ＡＵＴＯ

ＡＵＴＯ

４９

４９

Switch the camera on and check that no battery level warning (

X

, 

C

or 

V

) is displayed on the

screen (LCD monitor). If no icon is displayed, there is ample charge left in the battery.