Fujifilm 4700 Manual Do Utilizador

116

117

Nothing happens when I
use the camera switches
and dial.

No image appears when I
press the, “DISP” button.
There is no sound.

There is no picture or
sound on the TV.

• Camera malfunction.

• The Mode switch and Photography mode

dial has been moved to another setting.

• The battery exhausted.
• The Mode switch and Photography mode

dial has been moved to another setting.

• sounThe camera volume is set too low.
• The microphone was covered during

recording.

• The A/V cable is connected.
• The A/V cable is connected during movie

playback.

• The camera and TV are connected

incorrectly.

• The TV input is set to “TV”.
• The volume on the TV is set too low.

• Use  the  “POWER” switch to switch the

camera on again.

• Remove the battery, re-insert them and try

again.

• Load a new battery.
• Move the Mode dial to the correct setting.

• Adjust the volume.
• Take care not to cover the microphone

when recording.

• Disconnect the A/V cable.
• Connect the A/V cable correctly.

• Connect the TV and camera correctly.

• Set the TV input to “Video”.
• Adjust the volume.

I can’t use the flash to take
pictures.

The flash will not charge.

The playback image is too
dark even though I used
the flash.
The image is blurred.

I cannot format the
SmartMedia.
I cannot erase all the
frames.

• The Mode switch and Photography mode

dial has been moved to another setting.

• The flash is set to Suppressed Flash

mode(The flash is closed).

• You pressed the shutter button while the

flash was charging.

• No compatible SmartMedia is loaded.

• The camera is set to Suppressed Flash

mode.

• The camera is set to Macro Photography.
• The battery is exhausted.
• The subject is too far away.
• Your finger covering the flash.

• The lens is dirty
• The lens is zoomed to telephoto in Macro

mode.

• The SmartMedia is write-protected.

• The frame is protected.

• Set the Mode switch and Photography

mode dial to the correct setting.

• Set the flash to Auto, Red-Eye Reduction or

Forced Flash mode(Pop the flash unit up).

• Wait until charging is completed before

pressing the shutter button.

• Load a new SmartMedia, erase a frame, or

remove the write-protection.

• Set the flash to Auto, Red-Eye Reduction or

Forced Flash mode.

• Cancel Macro Photography.
• Load a new battery.
• Move closer to the subject.
• Hold the camera correctly.

• Clean the lens.
• Cancel Macro mode.

• Remove the write-protection.
(Peel off the write-protect sticker.)
• Remove the frame protection.