Fujifilm 2650 Manual Do Utilizador

Software needed for playing back movies, etc.

Launches the FinePixViewer 
software when a camera is 
connected.

Software used to read PDF-format documents on a 
personal computer. This software is needed to read the 
User’s Guides for FinePixViewer.

Creates a FinePix CD Album.

Used for videoconferencing (Windows only).

Allows you to display thumbnail lists of the 
images stored on your PC or in the camera, 
print the images individually or as an index, 
display the images at full size and perform 
some basic image processing.

✽ Note that the software configuration differs slightly depending on your operating system.

Connect the camera 
with “DSC” selected as 
the USB setting 
(

➡P.84). 

Connect the camera 
with “PC CAM” 
selected as the USB 
setting (

➡P.87).

Allows a digital camera to be used 
as USB Mass Storage (removable 
disk drive, card reader).

Allows a digital camera to be 
used as a PC Camera. 

6.1 The Software Components

When the camera is in Sleep mode, pressing
any button on the camera will switch the LCD
monitor back on. Sleep mode offers a useful
alternative to switching the camera off because
the camera is ready to use far more quickly.
Even when the camera is asleep, you can still
release the shutter and take pictures.

●

Power Save/Auto Power Off does not function when
a USB connection is being used.

●

Operation can also be restored by pressing buttons
other than the shutter button.

●

To switch the camera back on, briefly switch the
camera off and then on again.

The Sleep function does not operate when the
LCD monitor is switched off, while you are
setting the quality or when the camera is in
SET–UP or Playback mode. However, if the
camera controls are not used for 2 minutes, the
camera automatically switches off.

g POWER SAVE

hPower saving “ON” (default setting)
Power consumption is kept to a minimum to
prevent battery depletion. You should select the
“ON” setting when you are using alkaline
batteries.

iIf the camera is not used for approximately 30

seconds, the LCD monitor switches off temporarily
to reduce power consumption (Sleep mode).

iOnce the camera is in Sleep mode, if it is left

unused for a further 90 seconds, it is automatically
switched off.

iThe charging time for the flash increases slightly

because the flash charging power is reduced.

hPower saving “OFF”
Batteries are more likely to run flat since no
power reduction measures (sleep mode, etc.)
are used. However, this function automatically
switches the camera off if the camera is not
used for approximately 2 minutes.

ＰＯＳＴＶＩＥＷ

ＰＯＳＴＶＩＥＷ 

ＤＡＴＥ／ＴＩＭＥ 

ＵＳＢ ＭＯＤＥ

ＵＳＢ ＭＯＤＥ 

ＯＮ

ＯＮ 

ＰＯＷＥＲ ＳＡＶＥ 

ＯＮ

ＯＮ 

ＳＥＴ

ＳＥＴ 

ＳＥＴ−ＵＰ

ＳＥＴ−ＵＰ 

ＤＳＣ

ＤＳＣ 

ＢＡＣＫ

ＢＡＣＫ 

ＯＫ

ＯＫ