Fujifilm 40i Manual Do Utilizador

19

18

➀

Set the Mode dial to 

“ 0 ”

.

➁

Press the “MENU/OK” button to display the
menu on the LCD monitor. 

➂

Use “

d

” or “

c

” to select “MODE” and then use

“

a

(

)” or “

b

(

)” to select “SET-UP”. 

➃

Press the “MENU/OK” button.

➀

Use “

a

(

)” or “

b

(

)” to select “DATE/TIME”.

➁

Press the “MENU/OK” button.

●

See P.88 for more information on the items in the
“ 2” (SET-UP) mode menu.

●

If the AC power adapter has been connected or the
batteries have been installed for about half a day or
longer, the date and time settings will be retained for
about half a day after the AC power adapter has
been disconnected or the batteries have been
removed.

●

➀

●

➁

●

➂

●

➃

On

Flashing

On

On

On

Blank

Note that this only turns the camera on for audio
playback with the remote control connected.

Check the battery level warning when you switch
the camera on.

➀

The battery is fully charged.
(This icon is only displayed on the LCD panel
for 3 seconds after you switch the camera on.)

➁

The battery charge is too low. Fully charged
batteries should be installed as the power will
run out shortly.

➂

There is no charge at all in the batteries. The
icon disappears immediately and camera
operation stops. Install fully charged batteries.

●

The battery charge level can only be checked on the
remote control LCD panel when the remote control is
installed (

●

➀

●

➁

If the date and time settings are cleared when
you switch the camera on, a confirmation
screen appears. If you chose to reset the
date and time, proceed from step 

.