Fujifilm 50i Manual Do Utilizador

Página de 57
81
Macintosh
80
Macintosh
1. Switch on your Macintosh and start up Mac OS.
2. Check whether File Exchange is active.
To use a SmartMedia that is supported by the camera, the File Exchange utility
supplied with Mac OS must be running. Select the Extensions Manager in the
Control Panels and check that the File Exchange check box is ticked. If not, click in
the box so that an [X] appears and then restart your Macintosh.
Installing the Software
Before You Install the Software
■ The following applications are installed by the Installer:
FinePixViewer
DP Editor
Exif Launcher
QuickTime™
Audio Downloading Software
VideoImpression™
MacMP3 for FinePix
Acrobat
®
Reader™
When you install the USB driver, the following files are installed in the
“Extensions” folder:
“USB04CB_StorageShim”
“USB04CB_StorageDriver”
“USB04CB_VcShim”
“USB04CB_VcDriver”
Pre-installation Checklist
Installation on a Macintosh
■ Hardware and software requirements
To run this software, you must have the hardware and software described
below. Check your system before you begin the installation.
Compatible Mac
: Power Macintosh G3
✽1
, PowerBook G3
✽1
Power Macintosh G4, iMac, iBook, 
Power Macintosh G4 Cube, or PowerBook G4
Operating System
: Mac OS 8.6 to 9.1
RAM
: 64 MB minimum
✽2
Display
: 800 
× 600 pixels or better, at least 32,000 colors
Hard disk space
: Amount required for installation: 70 MB minimum
Amount required for operation: 300 MB minimum
Internet connection
✽3
: 56 kbps modem connection (recommended) or better
or an ISDN connection
Sound functions
✽4
: Speakers and microphone
✽1
Models with a USB port as a standard feature
✽2
Turn virtual memory on if necessary.
✽3
Required to use the FinePix Internet Service. The software can still be installed
even if you do not have an Internet connection.
✽4
Sound functions are required for audio input/output in VideoImpression.
• Connect the cradle directly to the Macintosh using the special USB cable. The
software may not operate correctly if you use an extension cable or connect the
cradle via a USB hub.
• Push the USB connector fully into the socket to ensure that it is securely connected.
The software may not operate correctly if the connection is faulty.
• Additional USB interface board is not guaranteed.
• Use the drivers (the Mass Storage Driver and PC Camera Driver) provided on the
enclosed CD-ROM. When older drivers are already installed on your PC, uninstall the
old versions and then re-install the drivers provided on the enclosed CD-ROM.
• This software is not compatible with Mac OS X.
NOTE