Samsung HMX-Q200 Manual Do Utilizador

73

Wireless network (HMX-QF20 only)

Configuring the network settings

You can configure network settings manually. Note that configuring 
these settings manually is not necessary in most cases. If your 
camcorder connected to the network after you followed the directions 
on page 72, your camcorder has adjusted these settings and you do 
not need to configure them manually.

Press the [Home ( 

 )]  button 

p touch Social Sharing.

Touch the Wi-Fi setting ( 

 )  tab. 

The camcorder automatically searches for available AP devices.

Touch the  

  tab next to an AP.

Touch each submenu and enter the required information.

Select an authentication type according to your AP’s setting. 
When you select Open or Shared, WPA is automatically 
set.

Select an encryption type according to your AP’s setting.

Enter the password using the virtual keyboard. 

¬page 75 

The default is Auto. You can select Manual to set the IP 
address manually.

•

Touch the  

   tab.

The camcorder connects to the network via the selected AP.

Even if AP authentication and Data Encryption have been detected, 
set the authentication mode to Open or Shared.
If the camcorder does not detect the AP automatically, you can set 
the network properties directly. 

¬page 74

Data encryption settings by authentication type are below:
- Open 

p Disabled or WEP

- Shared 

p WEP

- WPA-PSK 

p TKIP, AES, or TKIP/AES Mixed

When the Data Encryption function is set to WEP or TKIP for 
802.11n AP connection, you can access in the 802.11g mode. 
In the 802.11g mode, the network connection and speed are not 
guaranteed.

•

•

•

•

•