Hitachi VM-E220A Manual Do Utilizador

 

9. Continue programming as described above until you have entered up to four different segments. 
10. Load a blank tape, then set the VCR to the record pause mode. 

11. Point the remote control at the receiver on the VCR and press the COPY START button to start simple 
programmable edit. 
• The camcorder automatically searches for the beginning of the first segment and starts playback. The recording 
VCR automatically starts recording 
• After recording the first segment, the camcorder automatically searches for the beginning of the next segment 
and resumes playback. The recording VCR is automatically released from the record pause mode and resumes 
recording. 
• It continues recording and pausing until all the programmed segments are edited. 
12. When simple programmable edit is finished, the camcorder will enter the stop mode, and the VCR will enter 
the record pause mode. 

Note: If you make a mistake during programming, start again from the beginning or press the COUNTER 
RESET button to return to the previous steps one by one and enter the correct program data. 
Note: After the simple programmable edit is finished, the programmed data is erased. If you want to continue 
editing other segments, repeat steps 5 - 12. 
Note: Most VCRs (recording machine) may be released from the record pause mode if it continues for more 
than five minutes. 
Note: The dubbing start and end positions may slightly drift from the specified positions when certain VCRs 
are used. 

Press the PROGRAM button to remove the program display from the viewfinder. Then press the stop button on 
the recording VCR to set it to the stop mode. 

Note: If the CAM/OFF/VIDEO switch of the camcorder is set to OFF or CAM when the recording VCR is in 
the record pause mode, the VCR enters the record mode. 

1. To remove the lens hood, turn it counterclockwise. 

 

2. Remove both caps of the converter lens. 
3. Screw the lens into the threads on the camcorder lens assembly.