Heath Zenith 9700LeD Manual Do Utilizador

3

1.

Motion

Motion

nOte:  If  fixture  is  mounted  higher  than  8  ft.  (2.4
m),  aiming  the  sensor  down  will  reduce  coverage
distance.
The  detector  is  less  sensitive  to  motion  directly
towards it.

RANGE

10 5 1 TEST

ON-TIME

• Objects that change temperature rapidly, such as

heating vents and air conditioners. These heat
sources could cause false triggering.

• Areas where

pets or traffic may trigger the con-

trol.

•

nearby  large,  light-colored  objects  reflecting
light may trigger the shut-off feature. Do not point
other lights at the sensor.

70 ft.

(21 m)

8 ft.

(2.4 m)

180°

MIN

MAX

Sensor

3.  Loosen  the  clamp  screw

in the sensor ball joint and
gently rotate the sensor.

4.  Walk through the coverage

area noting where you are
when the lights turn on (also,
the  LED  will  flash  several
times  when  motion  is  de-
tected).  Move  the  sensor
head up, down, or sideways
to  change  the  coverage
area. 

5.  Adjust the RANGE as need-

ed. RANGE set too high may
increase false triggering.

6.

secure  the  sensor  head 
by  tightening  the  clamp 
screw.  Do  not  overtighten
the screw.

7.  Set  the  amount  of  TIME  you  want  the  lights

to stay on after motion is detected (1, 5, or 10
minutes).

Clamp
Screw

Ball Joint

Note: Sensor has a 1

1

/

2

 minute warm up period 

before it will detect motion. When first turned on
wait 1

1

/

2

minutes.

2.  Turn the RANGE control to the medium position

(halfway between MIN and MAX) and the ON-
TIME control to the TEST position.