Avalon Stoves DVL Insert EF II Manual Do Utilizador

Installation (for qualified installers only)

4080123

100-01174_002

Vent Location

•

A vent restrictor is built into the appliance to adjust the flow rate of exhaust gases.  This ensures
proper  combustion  for  all  vent  configurations.    Depending  upon  the  vent  configuration,  you
may  be  required  to  adjust  the  restrictor  position.    The  charts  for  acceptable  vent  configurations
detail  the  correct  vent  restrictor  position.

2”

Center Line

Inlet (3” Dia.)

Exhaust (4” Dia.)

Fireplace

Opening

1-1/2”

4-1/2”

14-3/4”

5-1/8”

NOTE: Vent location changes based

upon restrictor position. Position # 1 is

shown to the right. Each restrictor

position moves the vent location forward

(toward the fireplace opening)

approximately 1/4”.

Vent Configurations

Z.C. (Metal) Wood-Burning Fireplace

Inlet & Exhaust Re-Line

AAA

AAAA

Exhaust Only Re-Line

Direct Vent Cap

(part # 991)

Recommended Block-Off
Plate (non-combustible
metal and/or insulation).
Prevents odors from
chimney entering room.

6-5/8" to 3" & 4" Colinear

Adapter & Flashing

(Travis Part # 98900124)

A block-off plate must
seal the intake to the
chimney space. This
way air is drawn down
the chimney for
combustion air.

Block-Off Plate
(non-combustible
materials)

NOTE: You may use either re-line configuration with a masonry or zero-clearance fireplace.

Inlet

Masonry Fireplace

Any cracks or
damage inside the
chimney must be
repaired.

Exhaust

4" dia.

Gas Liner

Inlet

3" dia. Gas Liner

Exhaust

4" dia. Gas Liner