Avalon Stoves DVL Insert EF II Manual Do Utilizador

© Travis Industries

100-01174_002

The  insert  may  be  installed  without  surround  panels.      Mount  the  on/off  switch  and  rheostat  to  the
control  panel  under  the  burner  pan  (see  “Installation  of  the  On/Off  Switch  and  Rheostat” on page 19).

8"  x  10"  Rectangular

44-3/16"

33-3/8"

98500606

Arched (8” x 10”)

44-3/16"

33-3/8"

98500608

10”  x  13”  Rectangular

48-3/16"

36-3/8"

98500607

1

Follow  the  directions  below  to  install  the  side  panels.

Line up each side surround 

panel and insert two screws from 

the inside to secure in place.

5/16" Nutdriver

Pre-thread the holes on the surround 

panels with the screws included in the 

surround panel kit.

Run the rheostat wires, 

on/off switch wires, and 

power cord through the 

access hole on the 

insert

2

Follow  the  directions  below  to  install  the  top  panel.

Install the top panel so the 

two tabs insert into the slots 

on the side panels.

Top 
Panel

Top Trim

"L" Bracket

Right Side Trim

Slot for on/off 
switch and hole 
for rheostat

NOTE:  

These 3/8" 

stand-offs are 

not required 

and may be 

flattened.

Construct the panel trim.  Insert one leg of each "L" 

bracket into the top and side trim piece.  Align the 

trim to form a precise corner, then tighten the two set 

screws with a small standard screwdriver.  Slide the 

trim over the panels.

Tighten the set 

screws from the back 

side with a small 

standard screwdriver

"L" Bracket

Right Side 
Trim

Top Trim