Avalon Stoves DVL Insert EF II Manual Do Utilizador

Installation (for qualified installers only)

4080123

100-01174_002

Factory-Built (Metal) Wood-Burning Fireplace Requirements

N O T E : Any parts that are removed must be removed in a way that would allow them to be re-installed if the
insert is ever removed.

The damper ("A") and grate (with log set) ("B") must be removed (see the illustration below)

The smoke shelf ("C"), internal baffles ("D"), screen ("E"), masonry lining or refractory ("G" & "I"), and metal
or glass doors ("F") may be removed (if applicable)

The fireplace must be permanently marked to
indicate that it has been altered and is no longer
suitable for burning solid fuel (wood), unless the
removed parts are re-installed. Cutting of any sheet
metal parts is prohibited (removal of rivets or screws
is acceptable).

The insulation ("H"), and any structured rigid frame
members must not be removed or altered (side and
top of door frame, side and top of the face of the
fireplace, metal sides, etc.).

The metal floor ("J") may be removed to allow
additional room for installation of the insert. If the
floor is removed the insert must be placed directly
on the metal base of the metal fireplace.

AAA

AAAAAAAA

Hearth Requirements

The  heater  and  face  must  not  contact  combustible  surfaces.    A  non-combustible  hearth  extension
is  not  required.    However,  if  the  heater  is  installed  next  to  the  floor,  we  recommend  a  hearth  to
protect  the  flooring  surface  from  discoloration  or  other  negative  impact  from  the  heater.

Leveling Bolts

This  heater  includes
front  and  rear  leveling
bolts  to  accommodate
fireplaces  with  a  step-
down  firebox.

NOTE: To access the
rear leveling bolts,
remove the burner
(see page 39).

Use a 1/2” socket wrench

(with extension) to adjust

the leveling bolts.

To access the rear leveling bolts remove these

access plates (replace access plate and

gasket after adjustment).

Rear Leveling Bolt

Front Leveling Bolts

AAAAA

AAAA