Valor Auto Companion Inc. 739DVN Manual Do Utilizador
16
Remote Control Preparation
CAUTION! Do not connect the batteries to the remote control receiver until the wires are
connected to the burner control unit, as short circuit could result in destruction of the
electrical components.
connected to the burner control unit, as short circuit could result in destruction of the
electrical components.
Connect the wiring harness to the receiver box by pushing the wire connector on to the receiver circuit
board. The plug will only go on one way so please ensure that the wires are pointing up and the slot in
the board is in line with the tab on the wiring harness plug.
Connect the wires “A” (with the “L” terminals) to the connectors “B” on the control valve. Please note that
the connectors are different sizes; the smaller one fi ts to the lower connection on the valve.
Connect the wires “C” to the connectors “D” on the control valve. (Either wire can be fi tted to either
connector.)
Remove the remote control receiver lid.
Fit four 1.5 V batteries. Refi t the lid.
Place the remote control receiver of the Velcro pad.
Fit the 9 V battery to the handset transmitter.
board. The plug will only go on one way so please ensure that the wires are pointing up and the slot in
the board is in line with the tab on the wiring harness plug.
Connect the wires “A” (with the “L” terminals) to the connectors “B” on the control valve. Please note that
the connectors are different sizes; the smaller one fi ts to the lower connection on the valve.
Connect the wires “C” to the connectors “D” on the control valve. (Either wire can be fi tted to either
connector.)
Remove the remote control receiver lid.
Fit four 1.5 V batteries. Refi t the lid.
Place the remote control receiver of the Velcro pad.
Fit the 9 V battery to the handset transmitter.
1.
2.
3.
4.
5.
6.
7.
5.
6.
7.
Remote control receiver
A
C
Receiver
Cable
LED (green)
Sensor Opening
D
B