Regency Wraps P36-LPG4 Manual Do Utilizador

Regency

®

 P36-4 Gas Log Fireplace

Use the hook to pull the spring out until you 
can put the hook into the slot on the bottom 
door bracket. Repeat for 2nd spring.  See 
diagram 3.

The standard fl ush door comes with a black 
frame. To install the frame, simply hook the top 
door fl ange onto the top of the unit and swing 
the door towards the unit, diagram 1. 

Be careful that the glass gasket does not roll up; 
there must be a gap between the gasket and 
the door lip to ensure that the door sits securely 
on the unit. Diagram 2.

 
To remove the fl ush door, reverse the above 
steps.

Attach the round 
magnets to the 
back of the top trim 
piece and to the 
bottom trim piece, 
then attach trim to 
the top and bottom 
of Flush door.

1)  Install the top louvre by sliding the two 

bracket clips into the brackets located 
underneath the top of the fi rebox.

2)  The bottom louvre has a hinge that is 

attached (2 screws per hinge) to the lip on 
bottom of the unit.  

10) Place the embers on the front of the burner 

tray in the places shown on the photo.

11) Test fi re to ensure proper light off (make sure fl ame fl ows smoothly from one end of burner 

to the other).  If there is any fl ame hesitation, check that area for any blockage of the burner 
ports.