Regency Wraps P36-LPG4 Manual Do Utilizador

Regency

®

 P36-4 Gas Log Fireplace

1)  Run supplied 15' of wire through the right 

or left side gas inlet opening. Be careful not 
to damage wire.

2)  Connect wire to supplied wall switch and 

install into the receptacle box.

A wall thermostat may be installed if desired, 
connect the wires as per the wiring diagram. 
Use chart below to determine the maximum 
wire length.

Regency

®

 offers a programmable thermostat  

but any CSA, UCL or UL approved millivolt 
thermostat, 250-750 millivolt rated non-
anticipator type thermostat may be used.

Use the Regency

®

 Remote Control Kit  approved 

for this unit. Use of other systems may void 
your warranty.

The remote control kit comes with a hand held 
transmitter, a receiver and a wall mounting 
plate.

1)  Choose a convenient location on the wall 

to install the receiver and the receptacle 
box (protection from extreme heat is very 
important). Run wires from the fi replace to 
that location. Use Thermostat Wire Table.

2)  Connect the two wires to the gas valve. See 

diagram below.

3)  Install a 9V alkaline battery in both the 

receiver and the transmitter. Install the 
receiver and its cover in the wall. Switch the 
hand held remote transmitter to "remote" 
mode. The remote control is now ready for 
operation.

14 GA.
16 GA.
18 GA.
20 GA.
22 GA.

15.24 m

9.75 m
6.10 m
3.66 m
2.71 m

Wire Size                     Max. Length