Hearth & Home Technologies TIARAI-CES Manual Do Utilizador

Page  32

August 1, 2008

Heat & Glo · Tiara I B & Tiara II B · 7010-149M

   The shutter is located on the underside of the 

appliance, on the right side.  To adjust the shutter, loosen 
the wingnut. Retighten the wingnut after adjustment.

Moving the shutter bolt to the right closes the shutter. Moving 
the shutter bolt to the left, will open the shutter. Opening the 
shutter causes flames to become shorter and blue. Closing 
the shutter creates taller orange/yellow flames. 

NOTE:  Do not close so much as to cause a sooty flame. 
Improper adjustment can cause sooting in the firebox and/or 
on the outside of a house with a horizontal termination.

After adjustment, tighten nut to lock in place.

   Position baffl e on top of baffl e retainers on left 

and right sides.  Centering baffl e on retainers, ensure that the 
dark painted bevelled edge and darker painted baffl e bottom 
side faces toward the front viewing area of the fi rebox. Bend 
the center tabs up to prevent the baffl e from sliding out.

   Thread Allen bolts through nuts until fl ush.  The 

Allen bolts and nuts are included in the component pack inside 
the appliance fi rebox. 

   Slide assembled nuts and bolts into the slots on 

the legs with the nuts on the bottom.

   Use a 5/32 in. (4mm) Allen wrench to adjust legs 

up and down to desired level.

NOTE:  The brick supplied with the Tiara II-B is NOT  an 
optional accessory. The brick must be installed for safe and 
proper operation.

   

I

nstall rear panel by placing it behind the log pins 

fl ush and centered against back of fi rebox.

OPEN

CLOSE