Friedrich XQ06 Manual Do Utilizador

 6

  

To adjust temperature

5     WARMER - Press the TEMP 

   button to raise the 

temperature setting.

6   COOLER -  Press the TEMP 

   button to lower the 

temperature setting. 

To adjust fan speed

7   FAN SPEED - Press the FAN SPEED button to see 

the current setting.  Press again to change the fan 
speed.  F1 is the lowest setting (SLEEP / LOW), F2 is 
MEDIUM, F3 is HIGH, and SF is the SMART FAN 
setting.

To set the hour clock

8   SET HOUR CLOCK -  Press SET HOUR once to 

see the current clock setting.  Continue pressing the 
button until you arrive at the current time (Hour only).  
Minutes are not shown on the display.  Make sure that 
the A.M. / P.M. setting is correct.

To set the timer

NOTE: You can set the START and STOP times a minimum 
of one hour apart, and a maximum of 23 hours apart.

9    TIMER START - Press START to view the current 

start time for cooling.  Continue pressing the START 
button until you arrive at the start time you desire.  The 
start time for cooling will then be set.

10  TIMER STOP - Press the STOP button.  Continue 

pressing the STOP button until you arrive at the stop 
time you desire.  The stop time for cooling will then 
be set.

11  TIMER ON / OFF - Press the TIMER ON / OFF but-

ton to activate (light on) or deactivate (light off) the 
timer.  Once the on and off times have been selected, 
they  will  remain  in  memory  and  cycle  daily  until 
changed.

NOTE: If the unit is unplugged or the power is inter-
rupted, the SET HOUR function must be reset or the 
TIMER ON / OFF function will not work.

Additional RC1 wireless remote controls can be purchased 
from your Friedrich dealer.

How to use the remote control

To start unit

1     POWER - Press the POWER button once.  The unit 

will automatically start in the mode and fan speed it 
was last left on.

To set mode of operation

2      COOL - Press the COOL button to automatically 

switch the operating mode to COOL.

3      FAN ONLY - Press the FAN ONLY button if you want 

to run the fan only.  You may want to use this feature 
in conjunction with the EXHAUST if you want to 
exhaust stale air.  (The EXHAUST feature is located 
on the upper right side of the electronic control center 
on the air conditioner). See page 4, Figure 3.

4       MoneySaver

®

 - Press the MoneySaver

®

 button to ac-

tivate the MoneySaver

®

 feature. MoneySaver

®

 is the 

feature that cycles the fan with the compressor so that 
the fan does not run all the time.

8

10

4

7

1

11

9

3

2

5

6

Figure 4