Fujitsu 9319356051 Manual Do Utilizador

En-4

Remote Control Signal Receiver & MANUAL AUTO button
● When the battery in remote control is dead or the remote control is lost, press the 

MANUAL AUTO button can resume emergency operation.

● When the MANUAL AUTO button is pressed in for more than 10 seconds, the forced 

cooling operation will start.

● The forced cooling operation is used at the time of installation.

Only for authorized service personnel’s use.

● When the forced cooling operation starts by any chance, press the START/STOP but-

ton 

 to stop the operation.

Lights during the normal operation, and fl ashes slowly during the Automatic Defrosting operation.

If the TIMER indicator lamp fl ashes when the timer is operating, it indicates that a fault has occurred 
with the timer setting. (See page 23).

ECONOMY indicator lamp lights when ECONOMY OPERATION and MIN. HEAT OPERATION is 
operating.

Remote 

controller

Batteries

Air cleaning fi lters

Remote 

controller 

holder

Tapping screws

It opens at the same time of operation, 

and shuts when operation stops.
● 

Please do not touch by hand or put 

your fi nger into it during the open 

panel opening/shutting operation. 

Or your fi nger might be injured.

● 

Please do not move the open panel 

by hand. It may cause breakdown, 

vapor may condense near the outlet 

louvers and drops of water may drip 

from it if you move it forcibly.

● 

Please do not hang objects on open 

panel, or put objects into the panel 

while it is open. It causes breakdown.

● 

Before starting opera-

tion, make sure that the 

intake grille has been 

shut completely. 

(See page 20.)

Incomplete closing of 

the intake grille might 

have an effect on the 

proper working or 

performance of the air 

conditioner. 

9319356051_OM.indb   4

9319356051_OM.indb   4

12/5/2011   3:25:30 PM

12/5/2011   3:25:30 PM