Sony HM-982RW Manual Do Utilizador
64
Preparation section
Basic section
Application section
Knowledge section
Convenient recording of CD player output
Check the current play mode of the CD player.
2
1
1 Perform steps 1~3 of the procedure in ”Recording
on TAPE”.
‚
2 Load the recording source disc in the CD player.
¢
Make the preparations for recording.
Be sure to put the cassette deck in stop mode.
Records all tracks in a CD with a simple operation. (All-track recording)
Records a single CD track being played from the beginning. (Single-track recording)
Records a single CD track being played from the beginning. (Single-track recording)
One-touch edit recording
(O.T.E.)
All track recording
Single-track recording
If it is in play mode, stop it.
Select the desired CD track and play it.
Start recording.
3
÷ When either the playback or recording operation stops, the
other operation also stops.
÷ When you are operating the main unit, select “O.T.E. Mode”
in the menu mode then select “CD
=
=
=
=
=TAPE“ and press the
SET key to start recording.
÷ When recording completes, the tape stops after leaving a no-
sound blank of about 4 seconds.
Do not use a cassette tape with more than 90-minute recording time, for the tape used with such a cassette is very
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
To interrupt a recording
CD
TAPE
=
STOP
7
6
CD
CD
=TAPE
This system can record signals on Normal (TYPE ) and
High (TYPE ) position tapes. Remember that the Metal
(TYPE
High (TYPE ) position tapes. Remember that the Metal
(TYPE
) tapes cannot be used with this system.
Press the
7 (stop) key on the main unit or 7 STOP
key on the remote. (This stops both recording and
playback.)
playback.)
÷ Even when the O.T.E. CD=
=
=
=
=TAPE key is pressed in the middle
of a track, recording will start from the beginning of the track.