Honeywell T8524C Manual Do Utilizador

69-1055—1

2

T8524C,D MULTISTAGE MICROELECTRONIC THERMOSTATS

2. Use a pencil to mark the mounting holes. See Fig. 2.

3. Remove the wallplate from the wall and drill two

3/16 inch holes in the wall (if drywall) as marked. For
firmer material such as plaster or wood, drill two
7/32 inch holes. Gently tap anchors (provided) into
the drilled holes until flush with the wall.

4. Position the wallplate over the holes, pulling wires

through the wiring opening.

5. Loosely insert the mounting screws into the holes.

6. Tighten mounting screws.

All wiring must comply with local electrical codes and
ordinances. Refer to Fig. 3 for typical hookups. A letter
code is located near each terminal for identification.

Disconnect power before wiring to prevent
electrical shock or equipment damage.

1. Loosen the terminal screws on the wallplate and

connect the system wires. See Fig. 4.

Use 18 gauge, color-coded thermostat cable for
proper wiring.

2. Securely tighten each terminal screw.

3. Push excess wire back into the hole.

4. Plug the hole with nonflammable insulation to

prevent drafts from affecting the thermostat.

WIRES 
THROUGH WALL

WALL

MOUNTING 
HOLES

MOUNTING 
SCREWS

M6530

WALL
ANCHORS
(2)

5 FEET

[1.5 METERS]

YES

NO

NO

NO

M10106