Vocopro DA-3700 Manual Do Utilizador
7
Amplifier, mixer and external sound system connections
Music and Vocals
The DA-3700PRO’s LINE OUT (RCA) jacks can be used to connect to a second power amplifier, an external sound system or mixing
device. Note: The DA-3700 offers optimum performance when used as an amp for home sound systems and smaller performance
systems and speakers. See our VP Series power amplifiers for more professional applications at VocoPro.com or your nearest
VocoPro dealer.
The DA-3700PRO’s LINE OUT (RCA) jacks can be used to connect to a second power amplifier, an external sound system or mixing
device. Note: The DA-3700 offers optimum performance when used as an amp for home sound systems and smaller performance
systems and speakers. See our VP Series power amplifiers for more professional applications at VocoPro.com or your nearest
VocoPro dealer.
Use L/R RCA audio cables to connect to an amplifier, mixer or other external sound system. Connect from the L/R LINE OUTPUT
on the DA-3700PRO to the L/R audio input on your amp, mixer or sound system.
on the DA-3700PRO to the L/R audio input on your amp, mixer or sound system.
Outputting Vocals Independently
You can output vocals independently from the DA-3700PRO into a mixer from the L/R RCA MIC Outputs. Connect the L/R RCA
cable from the MIC OUTPUT to an Audio Input on your mixer.
You can output vocals independently from the DA-3700PRO into a mixer from the L/R RCA MIC Outputs. Connect the L/R RCA
cable from the MIC OUTPUT to an Audio Input on your mixer.
External speaker connection
You can connect directly to speakers using either MDP (banana plug) speaker cables or standard speaker wires. Be sure to correctly
match the polarities (+/-). Connect speakers rated no lower than 4-Ohms to the DA-3700 Pro. Please do not try to connect more
than one speaker per channel, as the load may exceed the amplifiers handling capacity, causing it to overload.
match the polarities (+/-). Connect speakers rated no lower than 4-Ohms to the DA-3700 Pro. Please do not try to connect more
than one speaker per channel, as the load may exceed the amplifiers handling capacity, causing it to overload.
If using standard speaker wire, unscrew each plastic bind until you are able to see an interior hole for speaker wire (this is easier to
locate when viewing from a side angle). Slide the speaker wires into the slots and tighten the plastic binds to tighten them in place. Be
sure there is no insulation on the speaker wire preventing conductivity.
locate when viewing from a side angle). Slide the speaker wires into the slots and tighten the plastic binds to tighten them in place. Be
sure there is no insulation on the speaker wire preventing conductivity.
Mixer/amp
Getting connected (cont.)
T
Speakers