Hisense Group H7 Manual Do Utilizador

III

IV

1. Read these instructions.

2. Keep these instructions. 

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance 

with the manufacturer's instructions.

8. Do not install near any heat sources such as radiators, 

heat registers, stoves, or other apparatus (including 

amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or 

grounding-type plug. A polarized plug has two blades with 

one wider than the other. A grounding type plug has two 

blades and a third grounding prong. The wide blade or the 

third prong are provided for your safety. If the provided 

plug does not fit into your outlet, consult an electrician for 

replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched 

particularly at plugs, convenience receptacles, and the 

point where they exit from the apparatus.

11. Only use attachments/accessories specified by the 

manufacturer.

12. Use only with cart, stand, tripod, 

bracket, or table specified by the 

manufacturer, or sold with the 

apparatus. When a cart is used, 

use caution when moving the cart/

apparatus combination to avoid injury 

from tip-over.

13. Unplug this apparatus during lightning storms or when 

unused for long periods of time.

14. Refer all servicing to qualified service personnel.   

Servicing is required when the apparatus has been 

damaged in any way, such as power-supply cord or plug 

is damaged, liquid has been spilled or objects have fallen 

into the apparatus, the apparatus has been exposed to 

rain or moisture, does not operate normally, or has been 

dropped.

15. Apparatus should not be exposed to dripping or 

splashing, and objects filled with liquids, such as vases, 

should not be placed on the apparatus.

16. An outside antenna system should not be located in the 

vicinity of overhead power lines or other electric light or 

power circuits, or where it can fall into such power lines 

or circuits. When installing an outside antenna system, 

extreme care should be taken to keep from touching 

such power lines or circuits, as contact with them might 

be fatal.

17. Do not overload wall outlets and extension cords, as this 

can result in a risk of fire or electric shock.

18. Do not push objects through any openings in this unit, 

as they may touch dangerous voltage points or short out 

parts that could result in fire or electric shock. Never spill 

or spray any type of liquid into the unit.

19. If an outside antenna or cable system is connected to the 

unit, be sure the antenna or cable system is grounded to 

provide some protection against voltage surges and built-

up static charges, Section 810 of the National Electrical 

Code, ANSI/NFPA 70, provides information with respect 

to proper grounding of the mast and supporting structure, 

grounding of the lead-in wire to an antenna discharge 

unit, size of grounding conductors, location of antenna 

discharge unit, connection to grounding electrodes, and 

requirements for the grounding electrode.

20. When replacement parts are required, be sure the service 

technician uses replacement parts specified by the 

manufacturer or those that have the same characteristics 

as the original part. Unauthorized substitutions may result 

in fire, electric shock or other hazards.

21. Upon completion of any service or repairs to this unit, 

ask the service technician to perform safety checks to 

determine that the unit is in proper operating condition.

22. When you connect the product to other equipment, turn 

off the power and unplug all of the equipment from the 

wall outlet. Failure to do so may cause an electric shock 

and serious personal injury. Read the owner's manual of 

the other equipment carefully and follow the instructions 

when making any connections.

23. Sudden high volume sound may cause hearing or 

speaker damage. When you use headphones, (if the unit 

is equipped with a headphone jack) keep the volume at a 

moderate level. If you use headphones continuously with 

high volume sound, it may cause hearing damage.

CONDENSATION: 
Moisture will form in the operating section of the unit if the 

unit is brought from cool surroundings into a warm room or 

if the temperature of the room rises suddenly. When this 

happens, unit's performance will be impaired. To prevent 

this, let the unit stand in its new surroundings for about an 

hour before switching it on, or make sure that the room 

temperature rises gradually.
Condensation may also form during the summer if the unit is 

exposed to the breeze from an air conditioner. In such cases, 

change the location of the unit.
HOW TO HANDLE THE LCD PANEL: 

 Do not press hard or jolt the LCD panel. It may cause the 

LCD panel glass to break and injury may occur.

 If the LCD panel is broken, make absolutely sure that you 

do not touch the liquid in the panel. This may cause skin 

inflammation.

If the liquid gets in your mouth, immediately gargle and 

consult with your doctor. Also, if the liquid gets in your eyes 

or touches your skin, consult with your doctor after rinsing 

for at least 15 minutes or longer in clean water.

Possible Adverse Effects on LCD Panel: 
If a fixed (non-moving) pattern remains on the LCD Panel 

for long periods of time, the image can become permanently 

engrained in the LCD Panel and cause subtle but permanent 

ghost images. This type of damage is NOT COVERED BY 

YOUR WARRANTY. Never leave your LCD Panel on for long 

periods of time while it is displaying the following formats or 

images:

 Fixed Images, such as stock tickers, video game patterns, 

TV station logos, and websites.

 Special Formats that do not use the entire screen. For 

example, viewing letterbox style (16:9) media on a normal 

(4:3) display (black bars at top and bottom of screen); or 

viewing normal style (4:3) media on a widescreen (16:9) 

display (black bars on left and right sides of screen).

 LCD Panels are manufactured using an extremely high 

level of precision technology, however sometimes parts 

of the screen may be missing picture elements or have 

luminous spots.

This is not a sign of a malfunction.

 Do not install the LCD Panel near electronic equipment that 

produces electromagnetic waves. Some equipment placed 

too near this unit may cause interference.

 Effect on infrared devices - There may be interference 

while using infrared devices such as infrared cordless 

headphones.

Declaration of Conformity
This device complies with part 15 of the FCC Rules. 

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference and (2)

This device must accept any interference received, including 

interference that may cause undesired operation.

Your TV also contains material that can be recycled and 

reused. For disposal or recycling information, contact your 

local authorities or the Electronic Industries Alliance at  

www.eia.org to find a recycler in your area.

TO USE AC POWER
1. The power cord is attached to the TV at the factory. 

2. Connect the AC cord into an AC outlet.

Do not connect this unit to the power using any device 

other than the supplied AC cord. This could cause fire, 

electrical shock, or damage.
Do not use with a voltage other than the power voltage 

specified. This could cause fire, electrical shock, or 

damage.

When this unit is not used for a long time, (e.g., away on 

a trip) in the interest of safety, be sure to unplug it from 

the AC outlet.
Do not plug/unplug the AC cord when your hands are 

wet. This may cause electrical shock.

The LCD panel contains almost 3 million thin film transistors, 

which provide exceptionally sharp video quality. Occasionally, 

a few non-active pixels may appear on the screen as a 

fixed black (in the case of a dead pixel), blue, green, or red 

point. These non-active pixels do not adversely affect the 

performance of your TV, and are not considered defects.