Novatel OM-20000149 Manual Do Utilizador
AG-STAR User Manual Rev 2
48
A.2.3
AG-STAR Connector and Cable Requirements
Custom cables for installing your AG-STAR can be created using the following guidelines:
•
Wire size: must be 0.5 mm-1.25 mm (20-16 AWG)
•
Batt + connection must be protected by 5A fast blow fuse
•
Serial data signals (TxD, RxD, signal ground) must be run in shielded cable.
•
CAN signal conductors must be twisted (40 twists/m, 12 twists/ft)
•
Use only the recommended mating connectors listed below. Use only gold plated pins
The connector used in the AG-STAR is an “AMPSEAL” dust and water sealed type produced by Tyco. The
following part numbers pertain to the mating connector required to make connections to the AG-STAR. These
numbers are provided for information only and are not available from NovAtel as separate parts.
following part numbers pertain to the mating connector required to make connections to the AG-STAR. These
numbers are provided for information only and are not available from NovAtel as separate parts.
Table 8: AG-STAR Mating Connectors
Table 9, Recommended Fuse and Fuse Holders on page 48 details the part numbers for recommended fuses
and fuse holders. These numbers are provided for information only and are not available from NovAtel as
separate parts.
and fuse holders. These numbers are provided for information only and are not available from NovAtel as
separate parts.
Table 9: Recommended Fuse and Fuse Holders
Connect shields to ground at the AG-STAR end only.
Failure to observe the given cable construction guidelines in this section will result in damage to
the wiring (not covered by warranty).
the wiring (not covered by warranty).
Product
Part Description
Company
Part Number
14-pin sealed receptacle
housing-black
housing-black
Tyco/AMP
776273-1
Gold plated pins for AG-STAR connector/loose
Pins, loose piece
Tyco/AMP
770854-3
Gold plated pins for AG-STAR connector/strip
Pins, strip (reel)
Tyco/AMP
770520-3
Seal Plug for unused pins on mating connector
Seal Plug
Tyco/AMP
770678-1
Fuse
Recommended Fuse/Fuse Holder
12 V System Fuse
(standard size blade)
(standard size blade)
ATO Silver Blade Fuse 5 A (32 V)
Littelfuse
0287005
Or Equivalent
12 V System Fuse
(mini size blade)
(mini size blade)
Mini Blade Fuse 5A (32 V)
Littelfuse
0297005
Or Equivalent
24 V System Fuse
High Reliability, Harsh Environment
(standard size blade)
High Reliability, Harsh Environment
(standard size blade)
FKS ATO Blade Fuse 5A (80 V)
Littelfuse
166.7000.450
Or Equivalent
Inline Fuse Holder
(for standard size blade)
(for standard size blade)
Waterproof ATO Fuse Holder
Littelfuse
FHAC0001
Or Equivalent
Inline Fuse Holder
(for mini size blade)
(for mini size blade)
Waterproof Mini Fuse Holder
Littelfuse
0FHM0001
Or Equivalent